User manual REMINGTON R-9500

[. . . ] When using an electrical appliance, basic precautions should always be observed, including the following. Read all instructions before using this appliance. An appliance should never be left unattended when it's plugged in, except when charging a rechargeable appliance. Close supervision is necessary when this appliance is used by, on, or near children or invalids. [. . . ] Wipe off the unit periodically with a damp cloth and remove any hair debris that has collected where the shaver sits. Your Smart Shaver can also be recharged by plugging it into the cord directly. Use only the charging adapter supplied with the shaver. Connect the cord to the shaver, then plug the charging adapter into the electrical outlet. a charging indicator light will come on. Your shaver cannot be overcharged, so you can leave it plugged in and charging between shaves. To preserve the life of the batteries, let them fully run out every six months, then recharge them for a full 24 hours. Cord/cordless rechargeable shavers can run directly off the cord if necessary. They will not recharge while you are shaving, so after shaving with the cord, turn the unit off and set it aside to charge. Cord/cordless shavers should not be used strictly as cord-operated shavers, as continued cord-only use will result in reduction of battery life. Quick Charge provides up to three weeks of shaving after a one-hour charge, or a single shave after a five-minutes charge. NOTE: If your shaver battery is completely discharged or the shaver has not been used for a long time, the shaver may not start when operated using the cord. If this happens, charge the shaver for approximately five minutes before shaving. You will need to keep the buttons pressed in as you move the upper portion away from the base. Pour the bottle of cleaning solution into the base of the unit through the opening where the filter was removed. Fill tank to the bottom of the fill tab. Plug the power cord into the cleaning base and then into an electrical outlet. Place the shaver into the unit, head side down, and slide its "tail" toward the "neck" of the base until it clicks into place. Charging Your shaver automatically begins to recharge as soon as it clicks into place in the cleaning base. While it is charging, the green indicator light will flash; when it is fully charged the green light will stop blinking and glow steadily. cleaning To activate cleaning mode , simply press the CLEAN button on the cleaning base. The amber indicator light flashes through the entire cleaning cycle, which lasts approximately 25 minutes. [. . . ] Just rub either product over your beard. Both absorb moisture and facial oils, helping set up the hairs so they enter the cutting chamber more easily. They make shaving quicker and more comfortable. When is it time to replace your head assembly? [. . . ]