User manual REMINGTON SPR 22

[. . . ] Owner's Owner's Manual for: Remington Model SPR 22 Side-by-Side Rifle Manual PAGE 2 . . . . . . . . THE TEN COMMANDMENTS OF FIREARM SAFETY IMPORTANT! READ ALL WARNINGS AND INSTRUCTIONS IN THIS MANUAL BEFORE USING THIS RIFLE PAGE 7 . . . . . . . . IMPORTANT PARTS OF THE FIREARM PAGE 10. . . . . . . . ASSEMBLY INSTRUCTIONS PAGE 11. . . . . . . . LOADING AND UNLOADING PAGE 13 . . . . . . FIRING 1 PAGE 15 . . . . . . DISASSEMBLY INSTRUCTIONS Safety is Critical to Performance. A superbly crafted gun is only as good as the hands that hold it. Shooting accidents are often caused by careless oversights such as failing to control the direction of the muzzle, failing to fully engage the safety, leaving ammunition in the chamber or using improper loads. These oversights can result in the destruction of life, limb or property. There's no calling back a bullet once it's been fired, so it's critical that you know the principles of safe gun handling and storage before you ever take your new Remington firearm out of the box. [. . . ] Double-trigger Model SPR 22 rifles are patterned after classic side-by-side firearms with two triggers. The front trigger always fires the right barrels. The back trigger always fires the left barrels. Picture 11 WARNING Never pull the trigger until you are actually ready to fire. Keep your fingers off the trigger and outside of the trigger guard until you are ready to pull the trigger and fire the rifle. When opening and closing the action and when engaging or disengaging the safety mechanism, make sure your fingers are outside of the trigger guard and away from the trigger. WARNING Never fire a double-trigger rifle by using two fingers because you may inadvertently pull both triggers at the same time resulting in a near simultaneous firing of both barrels. Use your index finger to pull one of the triggers to fire the first shot. After that shot is fired, release the trigger and move your index finger to the other trigger to fire the second shot. 8 External Control Parts (cont'd) Extractors: Model SPR 22 rifles are equipped with extractors for extracting the fired rounds when the action is opened. The extractor is located in the back center of the barrels, and is a single post extractor which will extract both rounds fired or unfired when the action is opened. (See Picture 12, 13) Picture 12 Picture 13 The Forend: The forend is the wooden grip piece piece which attaches to the barrels assembly and locks the barrels assembly into the receiver. (See Picture 14) The forend has a mechanical latch which is used to lock and unlock the forend to the barrels assembly. Never attempt to fire your rifle without having the forend locked in its proper position on the barrels assembly. Picture 14 Adjustable Sights: See (See Picture 15, 16) Picture 15 Picture 16 11mm Scope Rail: (See Picture 17) The Serial Number: The rifle's serial number is located under the top lever. Picture 17 9 Instructions For Assembly Of Rifle WARNING Before you begin to assemble the rifle, you MUST (1) look down the barrels from the breech end toward the muzzle end to make sure there is no ammunition in the chambers or obstructions in the barrels, and (2) make sure the safety is in the "safe" position. Your rifle was shipped with the barrels assembly (barrels and forend) detached from the receiver assembly. To assemble the rifle, follow these instructions: 1. Remove the plastic bags or wrapping covering the parts. Then remove the forend from the barrels by pulling outward on the mechanical lever in the lower midsection of the forend and tipping the forend out and away from the barrels while pulling the lever out. Now push the top lever to the right and hold with one hand. Holding the barrels with one hand, engage the lower locking lug located on the lower portion of the barrels with the receiver. The half round cut out on the lower locking lug fits around the round bar in the forward lower portion of the slot in the receiver. With the barrels engaged into the receiver, swing the barrels up into the locked position. The top lever should move back to the center once the barrels are locked into position. Note: The top lever may not move completely to the center on a new rifle until the gun is broken in. The top lever must move at least three quarters of its full travel distance. (See Pictures 20, 21, 22). 10 Instructions For Assembly Of Rifle (cont'd) Picture 20 Picture 21 Picture 22 4. [. . . ] You are responsible for the proper care and maintenance of your firearm and ammunition. PARTS AND SERVICE To Order Parts ALL PARTS ARE SUBJECT TO A $10. 00 CHARGE FOR SHIPPING AND HANDLING. Some parts are restricted and may only be installed by returning the rifle to us. When ordering parts, please state the Model, Gauge, Serial Number, and Finish Color. For parts information, call (321) 639-1432. Service To obtain information about returning your rifle for service or repairs, call (321) 639-1432. One Year Limited Warranty This rifle is warranted to the original retail customer for one year from the date of retail purchase against defects in material and workmanship. [. . . ]