User manual REMINGTON SPR 94

[. . . ] Owner's Owner's Manual for: Remington Model SPR 94 Over/Under Combination Rifle/Shotgun Manual PAGE 2 . . . . . . . . THE TEN COMMANDMENTS OF FIREARM SAFETY IMPORTANT! READ ALL WARNINGS AND INSTRUCTIONS IN THIS MANUAL BEFORE USING THIS SHOTGUN PAGE 7 . . . . . . . . IMPORTANT PARTS OF THE FIREARM PAGE 10. . . . . . . . ASSEMBLY INSTRUCTIONS PAGE 12. . . . . . . . LOADING AND UNLOADING PAGE 14 . . . . . . FIRING 1 PAGE 15 . . . . . . DISASSEMBLY INSTRUCTIONS Safety is Critical to Performance. A superbly crafted gun is only as good as the hands that hold it. Shooting accidents are often caused by careless oversights such as failing to control the direction of the muzzle, failing to fully engage the safety, leaving ammunition in the chamber or using improper loads. These oversights can result in the destruction of life, limb or property. There's no calling back a bullet once it's been fired, so it's critical that you know the principles of safe gun handling and storage before you ever take your new Remington firearm out of the box. [. . . ] The top lever should move Picture 17 back into the center once the barrels are locked in the position. Note: The top lever may not move completely to the center on a new combination rifle/shotgun until the gun is broken in. The top lever must move at least three quarters of its full travel distance. (See Pictures 18 and 19). Picture 18 Picture 19 10 Instructions For Assembly Of Combination Rifle/Shotgun (cont'd) 4. Now that the barrels have been locked into the receiver, you must reattach the forend to the barrels. Place the forend on the front curve of the receiver (the angle between the forend and barrels should be about 20 degrees). Keeping the contact between forend and receiver with an upward swing motion lock the forend into the barrels. While it may be necessary to push the latch into its final flat position, never force the latch into the position. WARNING: Never fire the gun unless the barrels are locked into position on the receiver and the forend is locked into the receiver and barrels. 6. Make sure the trigger block safety is engaged after completion of assembly (Red Dot covered). (See Picture 21). Picture 21 11 Loading and Unloading Your Combination Rifle/Shotgun WARNING Never load or fire combination rifle/shotgun unless the barrels are locked into position on the receiver, and the forend is locked into the receiver and barrels. WARNING Make sure the combination rifle/shotgun is pointed in a safe direction and the trigger block safety is engaged at all times while loading and unloading. NEVER allow fingers or other objects to contact the trigger(s) while loading or unloading. WARNING Do not disengage the trigger block safety until you are ready to fire and have the gun pointed safely downrange. TO LOAD: 1. Make sure the ammunition that you are using is the correct size and gauge. The barrel are marked with the gauge and chamber size. Shotgun Barrels marked 3" will use only 2 3/4" or 3" shot shells and must not be used with 3 1/2" shells. Shotgun Barrels marked with 2 3/4" will use only 2 3/4" and must not be used with or 3" or 3 1/2" shells. Visually inspect the chambers and barrels for obstructions by breaking open the combination rifle/shotgun by depressing the locking lever and tipping the barrels down. The chambers and barrels should be free of oil or grease or obstructions. After inspection, load the correct type of shot shell into the top barrel and the correct type of rifle cartridge into the bottom barrel. Make sure that the shells and cartridges are flush with the extractor. Then close the action by swinging the barrels up until they lock into the receiver and the locking latch should move to its fully locked position. (See Picture 25). Picture 23 Picture 24 Picture 25 12 Loading and Unloading Your Combination Rifle/Shotgun (cont'd) 3(cont'd). [. . . ] If you have lead shot choke tubes and intend to shoot steel shot cartridges or slugs, then you must use only the IC or Cylinder tubes. DO NOT fire steel shot or slugs in Modified, Improved Modified or Full lead shot choke tubes. If you have steel shot choke tubes, you may fire steel shot cartridges through any of those choke tubes. DO NOT fire slugs in Modified, Improved Modified or Full lead shot choke tubes or steel shot choke tubes. 21 Additional Information On Screw Choke Tubes: (cont'd) D. [. . . ]