User manual REMINGTON WDF-7000

[. . . ] WDF-7000_IB 8/28/06 9:59 AM Page 1 ® Use and Care Guide WDF-7000CS WDF-7000_IB 8/28/06 9:59 AM Page 2 IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be observed, including the following. Read all instructions before using this appliance. WARNING To reduce the risk of burns, fire, electric shock or injury to persons: This appliance is for household use only. An appliance should never be left unattended when it's plugged in, except when charging a rechargeable appliance. Close supervision is necessary when this appliance is used by, on, or near children or invalids. [. . . ] If the shaver is removed during the cleaning cycle it will be covered with the special cleaning/lubricating solution and will be unusable. Solution levels The cleaning solution will slowly evaporate with use. When the solution levels get low, the red replacement indicator light will begin to flash. This means you have enough cleaning solution left for approximately 5 more cleanings. If the red light stops blinking and glows steadily, the unit will not operate until the solution and filter have been replaced. Replacing the Filter and Solution Remington® cleaning solution and filters were specially designed for the WDF7000CS. The cleaning solution contains a high percentage of alcohol and a special oil that lubricates your shaver each time it is cleaned. The filter is specially designed to collect hair debris to keep solution clean. To refill the cleaning solution and replace the filter, follow the steps for "Preparing the System" above. But before replacing the top of the unit, rinse out the tank with fresh water and allow it to air dry to remove any sediment. !To avoid damage to the cleaning system, use only Remington® special cleaning solution. The Remington® replacement solution and filter, model #CC-100, is sold at many major retailers and online at www. remington-products. com. It can also be ordered by phone at 800-736-4648 in the U. S. or 800-268-0425 in Canada. To Charge Your Shaver (out of cleaning base) The WDF-7000CS can also be recharged by plugging the cord into the shaver directly. Use only the charging adapter supplied with the shaver. Connect the cord to the shaver, then plug the charging adapter into the electrical outlet. The shaver's charging indicator will light. Your shaver cannot be overcharged, so you can leave it plugged in and charging between shaves. To preserve the life of the batteries, let them fully run out every six months, then recharge them for a full 24 hours. NOTE: If your shaver battery is completely discharged or the shaver has not been used for a long time, charge the shaver for approximately one to two hours before shaving. After done charge for 16 hours for full charge. Operating the Charging/Cleaning System Plug the power cord into the cleaning base and then into an electrical outlet. Remove the shaver's clear plastic head guard and place the shaver into the unit, head side down. Push the shaver down and slide its "tail" toward the "neck" of the base until it clicks into place. [. . . ] Cut the two (2) metal tabs connecting the batteries to the PC board. Pull the batteries free from the adhesive tape, and dispose of properly. 3 2 4 1 5 5 6 7 6 9 10 9 8 12 13 WDF-7000_IB 8/28/06 9:59 AM Page 14 Warranty Warranty Service In the U. S. and Canada, service is provided by authorized service dealers. For the address of your nearest authorized service dealer, contact us at 800-736-4648 (in U. S. ), 800-268-0425 (in Canada), visit our website at www. remington-products. com or consult your local Yellow Pages under "ShaverElectric-Repair. " KEEP ORIGINAL SALES RECEIPT AS PROOF OF PURCHASE FOR WARRANTY PURPOSES. [. . . ]