User manual REMINGTON XR 1390

[. . . ] 9 Store the product at a temperature between 15°C and 35°C. 10 This appliance is not intended for commercial or salon use. 11 Suitable for use in a bath or shower. 2 ENGLISH D 4 13 3 6 2 C KEY FEATURES 1 2 3 4 5 6 7 8 On/off switch Head and Cutter assembly Individual flexing heads Hairpocket LED display Detail trimmer Trimmer release button Charging pins 9 10 11 12 13 14 Charging stand Adaptor (not shown) Head guard (not shown) Cleaning brush (not shown) Grooming styler head Adjustable comb for grooming styler head (not shown) AE 3 UA HR SL GR RO TR RU HUN PL 5 8 CZ SK 1 P FIN 5 9 S 7 DK I E F NL GB ENGLISH C GETTING STARTED It is recommended that you use your new shaver daily for up to four weeks to allow time for your beard and skin to become accustomed to the new shaving system. [. . . ] , • • • • • • • 4 CHARGING YOUR SHAVER Ensure the appliance is turned off. Connect the charging stand to the adaptor and then to the mains. The LED display will indicate when the shaver is fully charged. When charge is low ‘Lo’ will appear on the screen and will flash until the shaver is plugged in to charge. When charging, the LEDs blink in a clockwise rotation. When fully charged the minutes remaining will show ‘60’ minutes To preserve the life of your batteries, let them run out every 6 months then recharge for 24 hours. eNGLISH • The adaptor automatically adjusts to a mains voltage between 100V and 240V. € This appliance should be charged by approved safety isolating adaptors PA-0510E(K) with the output capacity of 5. F INSTRUCTIONS FOR USE , , • • • • • , • , • , • • • • SHAVING Note: This shaver is for cordless use only. Make sure your shaver is properly charged. Stretch the skin with your free hand so the hairs stand upright. We recommend you clean your product after each use. The easiest and most hygienic way to clean the appliance is by rinsing the appliance head after use with warm water. , CLEANING CAUTIONS 6 ENGLISH • • • , • • , • Pull the rotary shave face off the hair pocket (Fig. Tap out excess hair shavings from the hair pocket (Fig. Hair clippings can also be washed out of the hair pocket and or shave face by rinsing these under the tap. Once dry, snap the shave face back onto the hair pocket (Fig. CLEANING TRIMMER Lubricate the teeth of the trimmer every six months with a drop of sewing machine oil. Replacement parts and accessories are available to buy at http://www. Uk/ parts-accessories CLEANING GROOMING HEAD The easiest and most hygienic way to clean the grooming head is by rinsing the head after use with warm water. A cleaning brush can also be used to remove cut hair from the blades. BATTERY REMOVAL • • • • • • • • • • The battery must be removed from the appliance before it is scrapped. [. . . ] The appliance must be disconnected from the supply mains when removing the battery. Remove the head from the shaver (pull the head up and off). Using a small screwdriver, pry the ‘collar’ off of the top of the handle. Using a small screwdriver, pry the front cover from the body. [. . . ]