Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual REVOX RECONTROL M218. We hope that this REVOX RECONTROL M218 user guide will be useful to you.
Lastmanuals help download the user guide REVOX RECONTROL M218.
You may also download the following manuals related to this product:
REVOX RECONTROL M218 CONNECTION PLAN (95 ko)
Manual abstract: user guide REVOX RECONTROL M218
Detailed instructions for use are in the User's Guide.
[. . . ] REVOX
The Philosophy of Excellence
M218
M218 Connection plan
The M218 wall-mounted remote control panel enables you to control additional room amplifiers. In conjunction with an interface (M200, M201), it can also be used to control the M51. [. . . ] Screw the M218 board onto the flush mounting box using either the slot-holes at the sides or the drilled holes located at the corners. Please note: In either case, you must make sure that the screws are only finger tightened, otherwise there is a danger of cracks occurring in the board. Now you can clip in the corresponding frame with the blanking plate. There are lengthwise internal grooves provided for the Jung and Gira systems:
V209/ 219 connection panel External IR Receiver
Options
AB
(DIN plug view: solder side) VCC ( 10Volt)
7 6 3 1 524
There are two solder pad fields on the rear of the board, labelled A and B (see Connection plan). the factory setting for both these pads is open, i. e. Option A In some cases, it can be advantageous to turn the IR receiver off. Solder pad A closed (solder bridge in place) IR receiver: Off Solder pad A open (no solder bridge in place) IR receiver: On
Data IR
Earth: GND As well as the earth on PIN 2, the housing of the 7-pin DIN plug should also be earthed.
Technical data
The external trapezoid shaped cutouts should be used with the Merten system: Option B Using option B, you can re-address the tuner command (remote address) from tuner to AUX3. This is only necessary if a second tuner has been built into the M51. In this way, for example, you can listen to the first tuner in the main room (and Zone 1) and independently of this, use the second tuner in Zones 2 4. M51 Setup / Remote Menu Remote button "Tuner" is selecting "FM Tuner" in slot 1 Remote button "Aux3" is selecting "FM Tuner" in slot 2
TUNER CD SERVER AUX2
Tip: Up to 5 M218 can be switched in parallel Max. [. . . ] If he can't give you the help you need, send the M218 carriage free and without any accessories to your national Sales Office. Please supply a complete description of the problem and a full return postal address.
REVOX recommends the use of a 2-core, screened cable (microphone cable), where the screening us used as the earth. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE REVOX RECONTROL M218
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual REVOX RECONTROL M218 will begin.