User manual REX RF 320

[. . . ] DO NOT USE SHARP INSTRUMENTS to scrape off frost or ice. Frost may be removed by using the scraper provided. Under no circumstances should solid ice be forced off the liner. Solid ice should be allowed to thaw when defrosting the appliance. [. . . ] Push appliance into the housing until stop strip (A) touches the kitchen unit. D567 A Fig. 4 Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position. D723 D C Press in the joint covers between the appliance and the kitchen unit. Fig. 6 Apply covers (B) on joint cover lugs and into hinge holes. B D726 Position the runners (A) at the top and bottom of the inside of the kitchen unit as shown in Fig. and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. Fig. 7 A 20m m PR33 14 Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. Fig. 8 8mm PR34 Remove the little plates and make the holes with a diam. Replace the little platee over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. PR35 Fig. 10 If the appliance is to be fitted laterally to the kitchen unit, it will be sufficient to loosen the screws of the little plates (G), move them as shown in Fig. Fit the cover (H). D E D734 The doors can be opened using the sliding systempreviously illustrated, or one of the two doors can be opened by fitting the small handle supplied as an accessory. Fig. 11 Electrical connection D029 Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. TECHNICAL SPECIFICATIONS The technical data is indicated in the rating plate on the left side inside the appliance. GB 15 USE Operation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the «O» (STOP) position. The appliance will start to operate. GB refrigerating compartment temperature might drop below 0°C. If this occurs reset thermostat knob to a warmer setting. [. . . ] Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. D037 Fig. 16 D068 18 MAINTENANCE Unplug the appliance before carrying out any maintenance operation. GB Interior light The light bulb inside the refrigerator compartment can be reached as follows: Internal clearing s Never use metal objects for clearing your appliance as it may get damaged. When performing a complete defrosting, wash the internal surfaces of the freezer with lukewarm water and bicarbonate; rinse and then accurately dry. unscrew the light cover securing screws; unhook the moving part by pressing it as shown in the figure. s External clearing Wash the outer body with lukewarm water and soap. Periodically use a clearing polish to keep the outer body shining. [. . . ]