User manual REX RLB64XP

[. . . ] Children should not be allowed to tamper with the controls or play with the product. It is dangerous to alter the specifications or modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Before any cleaning or maintenance work is carried out, be sure to switch off and unplug the appliance. [. . . ] For this purpose the supply cable plug incorporates a special earth contact. If the sockets of your domestic wiring system are 2222 680-53 09/97 3 Door reversibility Before carrying out any work, remove the plug from the power socket. Slide the ventilation grille into the guide rails and remove the left-hand side (1) (Fig. Changing the door opening direction to the left Unscrew pins (A) at top and bottom and remove the corresponding spacers. Unscrew screws (C) and move the right-hand hinges (top and bottom) towards the inside and the left-hand hinges (top and bottom) towards the outside. Re-insert the screws into holes (D) (Fig. Slide the ventilation grille into the guide rails and remove the right-hand side (2) (Fig. 1 1 2 D614 Building the appliance in under a worktop Remove pins (A), spacers (B) and the door (Fig. 2 E Fasten the side panel to the upper and lower hinge by following Fig. Put the door back into position, with pins (A) and spacers (B) (Fig. 3 D104 Fasten the side panel to the rear of the appliance with the fixing brackets (Fig. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. PR34 Fig. 11 PR35 Inner door reversal Using a screwdriver release bracket (1) by pressing on the internal spring (Fig. 12) and withdraw it from its seat together with the door; remove plug (2) and fit it in the hole left open on the opposite side; turn the door through 180°, remove the bracket (1) and refit it on the opposite side. Refit the door and insert the top pin and bottom bracket (1), pushing it into place. To ensure correct storage of food, the door is fitted with a simple spring device which holds it in the open position until it is properly closed. PR140 Fig. 12 180° 2 1 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ± 6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. TECHNICAL SPECIFICATION The technical data is indicated in the rating plate on the left side inside the appliance. 6 GB USE Operation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the «O» (STOP) position. The appliance will start to operate. GB Fresh food refrigeration To obtain the best performance: do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour. [. . . ] To stop operation, simply turn the thermostat knob to position «O». Important If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. 7 Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. 13 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be adjusted in height. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. D040 Fig. [. . . ]