User manual RICOH AFICIO 2020D PRINTER REFERENCE 2

[. . . ] Printer/Scanner Unit Type 2018 Operating Instructions Printer Reference 2 Setting Up the Printer Driver and Canceling a Print Job Troubleshooting Printer Features Appendix Read this manual carefully before you use this machine and keep it handy for future reference. For safe and correct use, be sure to read the Safety Information in the "Copy Reference" before using the machine. Introduction This manual contains detailed instructions and notes on the operation and use of this machine. For your safety and benefit, read this manual carefully before using the machine. Keep this manual in a handy place for quick reference. [. . . ] If the cable is damaged or worn, replace it. See "Connecting the Machine", Printer Reference 1. Was the interface cable connected after the machine was turned on?Is the signal status satisfactory when using wireless LAN in infrastructure mode ?Connect the interface cable before turning on the machine. To check signal status, press the {User Tools/Counter} key, and then } select [System Settings] using {U} or {T}. On the [Interface Settings], select [IEEE802. 11b], and then select [Wireless LAN Signal] using {U}or {T}. If signal quality is poor, remove objects that might cause interference. Note You can check signal status only when using wireless LAN in infrastructure mode. When using wireless LAN, is the SSID correctly set?When using wireless LAN, is the access point correctly set?Check using the machine's control panel that the SSID is correctly set. See "Interface Settings/IEEE 802. 11b (Option)", Network Guide. Check access point settings when in infrastructure mode. Depending on the access point, client access may be limited by MAC address. Also, check there are no problems in transmission between access point and wired clients, and between access point and wireless clients. 15 Troubleshooting Possible Cause When using wireless LAN, is the LED on the wireless LAN card lit or blinking?Is the wireless LAN being used in ad hoc mode?Solutions Confirm the orange LED is lit, and the green LED is lit or blinks during transmission. See "Turning On the Power", Copy Reference. Otherwise, configure [IEEE 802. 11b] in [Interface Settings] in [System Settings]. See "Setting Up the Machine on a Network", Network Guide. Did you change the option settings on the machine?When using the RPCSTM printer driver on Windows 2000 and connecting with IEEE 1394, an error may occur if you change the option settings on the machine. In this case, follow the procedure below: A Unplug the IEEE 1394 interface cables connected to the compu- 2 ter. B Run the utility tool for the IEEE 1394 interface board, which is stored in the following path on the CD-ROM "Printer Drivers and Utilities". [. . . ] · The printer driver data format is binary, and the data format selected on the display panel is TBCP. Note Default: Binary Resolution You can set the print resolution in dots per inch. · 300 dpi · 600 dpi Note Default: 600 dpi 35 Printer Features 3 36 4. Appendix Collate and Rotating Collate If you select the collate function on the printer driver, the machine will store print data in memory and automatically collate the printouts. The collate function can be turned on or off from the printer driver. [. . . ]