User manual RICOH MP7060S

[. . . ] NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installlation. [. . . ] 75MB or more free space. (The free space needed for writing depends on the quantity of data. )*1 Adaptec Inc. 5. 25-inch half height bay required +5V/+12V power socket required Windows 98/95, Windows NT Workstation Ver. 4. 0 (Service Pack 3) or later Ricoh, Mitsubishi Chemical, Taiyo Yuden, Mitsui Chemicals, Ritek, CMC, Princo, TDK or Kodak discs are recommended. MP 7060S Series Hard disk SCSI Interface Drive bay Power Software Required OS CD-R, CD-RW discs Occasionally the CD-R and CD-RW discs written by the CD-R/RW drive cannot be read by other CD drives*2. These unreadable discs should be read using the CD-R/RW drive. * 1 For write at 6X speed, average access time of 12 msec or less and data transfer speed of 5 MB/sec or greater are recommended. 2 * The disc written using the CD-R/RW drive may not be readable by CDROMs other than Multi-read compatible (Random UDF compatible) CDROMs. Multiread compatible (Random UDF compatible) CD-ROMs are: (1) CD-ROMs that can read low reflectance (2) CD-ROMs that support Packet Write. 2 2. Drive functions and settings 2. 1 Front Panel Disc tray Volume control Headphone jack Eject button Drive activity indicator Name Disc tray Eject button Volume control Headphone jack Drive activity indicator Function This is the tray for the disc. Place the disc on the ejected disc tray, then lightly push the tray (or push the eject button) and the CD will be mounted. Don't use force to pull out or push in the disc tray. This might cause damage to the loading section of the drive. This is the button used to eject or insert in the disc tray. This is used to adjust the output volume of the headphone jack. It can't be used to adjust the output volume for the audio output connectors on the rear panel. Turn the volume down before turning on the power. Sudden loud noises can damage your hearing. This jack is for connecting headphones or mini-speakers. This indicator lights green when the power is turned on. When a disc is mounted into the drive and the disc is being accessed, it flashes or lights orange. When the disc is not being accessed, it lights green. When an illegal disc is mounted or hardware trouble occurs, the indicator blinks. 3 MP 7060S Series 2. 2 Rear panel Option connector SCSI interface connector Power connector MP 7060S Series Audio output connector Name Power Connector Function Connects to the power supply (5- and 12-V DC) of the host computer. Be careful to connect with the proper polarity. [. . . ] Follow the following procedures in such a case. Don't use this feature except in an emergency. (1) Turn the power to OFF. (2) Poke a fine tipped object into the small hole above the eject button. The front door pops open and the disk tray comes partway out. (3) Pull the front door to open it all the way, then grip the disc tray between thumb and forefinger and gently pull it straight out. This feature is a last measure to be used only in an emergency. [. . . ]