User manual RICOH MP7063A

[. . . ] NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installlation. [. . . ] Windows NT Workstation Ver. 4. 0 and Windows 2000: 64MB or more recommended Hard disk with average access time of 19msec or less, and data transfer speed of 1, 200KB/sec or greater. 150MB or more free space. (The free space needed for writing depends on the quantity of data. ) Enhanced-IDE interface (as Primary Slave, Secondary Master, or Slave) 5. 25-inch half height bay required +5V/+12V power socket required CD-R: CD-RW: *1 Ricoh, Mitsubishi Chemical, Taiyo Yuden, Mitsui Chemicals, TDK and Kodak discs Ricoh and Mitsubishi Chemical discs*1 CPU Memory Harddisk Interface Drive bay Power Recommendation discs The disc written using the CD-R/RW drive may not be readable by CD-ROM drives. Multi-read compatible (Random UDF compatible) drives are necessary. Multi-read compatible (Random UDF compatible) drives are: · · Drives that can read low reflectivity discs. Drives that support Packet Write. 6 Front Panel 1. Disc tray This is the tray for the disc. Place the disc on the ejected disc tray, then lightly push the tray (or push the eject button) and the disc will be mounted. Caution Don't use force to pull out or push in the disc tray. This might cause damage to the loading section of the drive. 2. Headphone jack This jack is for connecting headphones or mini-speakers. 3. Volume control This is used to adjust the output volume of the headphone jack. It can't be used to adjust the output volume for the audio output connectors on the rear panel. Caution Turn the volume down before turning on the power. Sudden loud noises can damage your hearing. 4. Busy indicator This indicator lights green when a disc is mounted into the drive. When the disc is being accessed, it flashes or lights green. If a disc is not mounted, the indicator does not light even when the power is turned on. When a illegal disc is loaded or some hardware trouble occurs, the indicator blinks. 5. Eject button This is the button used to eject or insert in the disc tray. 6. Emergency eject hole This drive has a function that allows the disc to be ejected manually if this becomes necessary in an emergency such as failure of the drive or a power outage. Caution This feature is a last measure to be used only in an emergency. Using it excessively will cause malfunction. 7 Rear panel 1. Analog Audio Output Connector Provides output to a sound card (Analog signal). 2. [. . . ] When the disc tray is in the ejected position, dust and other debris will enter, possibly causing read errors, write errors, or drive failure. 25 Emergency Eject This drive has a function that allows the CD to be ejected manually, if this becomes necessary in an emergency such as failure of the drive or a power outage. Follow the following procedures in such a case. Caution This feature is a last measure to be used only in an emergency. Using it excessively will cause malfunction. 1. [. . . ]