User manual RICOH MP7080A

[. . . ] Conventions Introduction Handling Procedures Features System environment Drive functions and settings Contents Conventions Introduction Handling Procedures Features Installing the Drive How to Use the Drive Specifications System environment Drive functions and settings Installing the Drive How to Use the Drive Specifications NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installlation. [. . . ] (Mode1, Mode2, Form1)[Read only] 1, 362 KB/sec. (Mode2, From2) Average access time Initial processing time 120msec. or less horizontal/vertical Format CD-DA CD-ROM CD-Extra CD-ROM XA Photo CD*3 CD-i*3 Video-CD CD-Text Write Read Play*2 Mounting direction Compatible formats * * * * * * * * * * * * * * * * * * Loading system Power Power consumption Weight Dimensions Reliability Tray type (automatic loading/eject) DC5V, DC12V 12w max. 146. 0 X 193. 0 X 41. 3mm Error Rate: MTBF: MTTR: 10-12 bits or less 100, 000hours or greater Within 30 minutes Environmental Conditions Temperature Humidity Vibration When operating 5°C to 40°C (No air cooling) 55% to 90% R. H. (No condensation) 0. 035mmpp(10 to 45Hz) 0. 025mmpp(45 to 65Hz) 0. 2 X 9. 8 m/s2 (65 to 150Hz) When not operating -30°C to 65°C 5% to 95% R. H. (No condensation) 1 X 9. 8 m/s2 (5 to 300Hz) Shock Environmental dust 2 X 9. 8 m/s2 40 X 9. 8 m/s2 (6msec. half sine) Class 3 million or less (3 million particles of 0. 5 micron dustper cubic foot or less) *1 Speed is automatically reduced if reading is unsuccessful. Also, "Read" means transferring data. *3 CD-i and Photo-CD discs require special reader/player. Also, Photo-CD requires a license from Kodak. The drive's appearance and specifications may change without notice. Disc CD-R Characteristic External diameter Dimensions Internal diameter Thickness Recording area (User area) Time Recording capacity Track pitch Substrate material Capacity Linear speed 80min. *1 700MB 1. 2m/s CD-R ø120mm ø15mm 1. 2mm ø50 to 116mm 74min. 650MB 1. 2m/s 1. 6 ± 0. 1µm Polycarbonate Organic pigment (phthalocya-nine) / Au or Ag lamination (Organic protective layer attached) 65% or more 70µm or less 0. 4° or less 6 to 7mW(at :785nm, NA:0. 5) 63min. 550MB 1. 4m/s 80min. *2 700MB 1. 2m/s 1. 6 ± 0. 1µm Polycarbonate Ag-In-Sb-Te phase change recording material 15 to 20% 70µm or less 0. 4° or less 8 to 14mW(at :785nm, NA:0. 5) CD-RW CD-RW ø120mm ø15mm 1. 2mm ø50 to 116mm 74min. 650MB 1. 2m/s Recording material Reflectance (R to p) Eccentricity Maximum camber angle Recommended recording power Playback power Playback stability 1mW or less or more (Playback power = 0. 7mW) -5 to 55°C 106times 1mW or less 106times or more (Playback power = 1mW) 10 to 40°C 10 to 80%RH 30 years or more (5 to 25°, 5 to 60%RH) 1, 000 times or more Environment for use 5 to 95%RH Storage life Number of rewrites * * 100 years or more (5 to 25°C, 5 to 60%RH Avoiding direct sunlight) ------------ The above specifications are for Ricoh CD-R and CD-RW discs Recommended Discs CD-R (74min. /63min. ) : Ricoh, Taiyo Yuden, Mitsubishi Chemical, Mitsui Chemicals, Ritek, CMC, Princo, TDK, Kodak, Memorex, Philips, and Maxell discs Taiyo Yuden, TDK, Maxell, Philips CD-R (80min. )*1 : CD-RW : Rioch, Mitsubishi Chemical, Memorex Philips CD-RW (80min. )*2 : For the latest disc information, please refer to Ricoh's website. Drive functions and settings Front Panel | Rear panel Front Panel 1. Disc tray This is the tray for the disc. Always turn the power OFF when connecting or disconnecting the cable. 5. Power Connector Connects to the power supply (5 and 12V DC) of the host computer. Caution Be careful to connect with the proper way. Connecting the wrong way may damage the system (and is not guaranteed). Emergency Eject This drive has a function that allows the CD to be ejected manually, if this becomes necessary in an emergency such as failure of the drive or a power outage. Follow the following procedures in such a case. Caution This feature is a last measure to be used only in an emergency. Using it excessively will cause malfunction. 1. Insert a fine tipped object into the emergency eject hole. The front door pops open and the disk tray comes partway out. Pull the front door to open it all the way, then grip the disc tray between thumb and forefinger and gently pull it straight out. Note If you cannot get a good grip on the disc tray with your fingers, use a steel binder clip or spring clamp to pull it out. Disc ejection 1. Slowly take the disc out of the disc tray 3. [. . . ] Device Drivers 3. Mounting the Drive 1. Remove the 5 inch drive bay panel from the computer. Refer to the manual for the computer for details. 2. Do not apply excessive pressure to the cables inside the computer. 3. [. . . ]