User manual RIP CURL OCEANSEARCH TIDE

[. . . ] INDEX Tide watches - Analogue / Digital Tide watches - Oceansearch Tide Oceantide Automatic Mechanical watches Day/Date 24 Hour Time watches Date 24 Hour Time watches Digital surf watches - module 1 - module 2 - module 3 - module 4 Day/Date/Time watches Watch bezel Instructions Strap changing Instructions Adjusting Stainless steel straps Recommended usage table & testing Warranty and care procedures Page 5 Page 13 Page 25 Page 33 Page 35 Page 36 Page 39 Page 45 Page 49 Page 54 Page 59 Page 61 Page 63 Page 64 Page 66 Page 68 3 Tidemaster 2 Congratulations on your purchase of a new Tidemaster 2 tide watch. Your watch has been specifically designed to help you score the best surf. Programmed with tide charts for 200 beaches, spot X function easily set to thousands’s of beaches world wide, future tide function, sunrise & sunset times, moon phase, timer, stop watch, dual time, alarms, light…enjoy!PATENT NUMBERS – USA # 5115417, FRANCE and UNITED KINGDOM # 04 61181 AUSTRALIA # 626400 DESCRIPTION OF MODES AND DISPLAYS TIDE / DATE / TIME MODE (main screen) - Note; Set your local time, date and other basic set up functions in this mode. [. . . ] • Push START/STOP the Date will flash, advance the Date with LAP/RESET till correct. • Push START/STOP the Hour will flash, advance the Hour with LAP/RESET to see the Tide conditions for selected Month, Date by Hour. Important: Oceantide watches must not be used for navigation at any time. Oceantide watches give an indication of tide conditions. They approximate the tides based upon average intervals and lunar cycles. Local tide conditions can vary from their indicated display. 31 AUTOMATIC MECHANICAL WATCHES A B Crown GETTING THE WATCH STARTED Automatic mechanical watches do not require a battery. There are 2 methods of starting your watch. You can wind the watch turning the crown in a clockwise direction approximately 15 times. You can also wind your watch by swinging your arm. We recommend you 1st wind the watch to get it started and then by wearing the watch you will continue to give power to the watch. NOTE : * When you take your watch off the power reserve is approx 24 to 36 hours. SETTING THE TIME Pull the crown out to position B. Turn the hour/minute hands in a clockwise direction to set the time. For the watch to be properly sealed, the crown must be fully pushed in. Never pull the crown out when the watch is in water or is wet. 33 DAY DATE 24HR TIME WATCHES SETTING PROCEDURE DAY HOUR & 24 HOUR MINUTE SECOND SETTING THE DAY Pull the crown out to position C. DATE Continually turn the hour / DAY (OF THE WEEK) minute hands in a clockwise 24 HOUR HAND direction to set a day. NOTE : * The day changes somewhere between 0:00a. m. * Do not set the day by turning the crown in counterclockwise direction. DAY (OF ABC Crown A B C THE WEEK) Crown SETTING THE TIME HOUR DATE After setting the day, set the hour and 24 HAND minute hands (and 24 hour). Turn the hour / minute hands in a clockwise direction to set the time. NOTE : * Make sure you have correctly set A. M. by the 24 hour hand. SETTING THE DATE Pull the crown out position B. Turn the crown counterclockwise to set the date quickly. NOTE : * Do not set the date between the hours 9:00p. m. [. . . ] All warranty claims MUST be sent with a purchase receipt clearly showing the purchase date. The warranty book is not proof of purchase without a purchase receipt. A purchase receipt is the cash register receipt or your credit card statement. NOTE : Rip Curl reserves the right to repair or replace, with an equivalent style, any warranty watch. 70 Warranty and Service Enquires : Australia Rip Curl Pty Ltd Watch Service Centre 101 Surfcoast Hwy, Torquay, Vic. [. . . ]