User manual RL FLO-MASTER 1402M

[. . . ] ALWAYS RELEASE pressure in sprayer before servicing. DO NOT alter the sprayer or any components. acids, chlorines and bleach), corrosive, heated or self-heating solutions with this sprayer. · DO NOT store liquids in the sprayer. [. . . ] ALWAYS RELEASE pressure in sprayer before servicing. NEVER leave pressurized sprayer unattended. E. If the chemical is stored in the tank, it can clog the system as it dries and destroy the seals and other components. To prolong its life, clean the sprayer after each use. After using water-based products, rinse thoroughly with soapy water then clean water, being sure to flush out the hose and flow control. After spraying solvent or oilbased products, follow the chemical manufacturers' recommended cleaning procedure, following up with a thorough rinsing and flushing of the sprayer, hose and flow control with soapy water then clean water. To store the sprayer, remove the complete hose assembly (hose w/siphon tube, wand, flow control) from the tank. For proper drainage and drying, lock flow control lever on. Loosen pump assembly, but leave in the tank. Store all components in a clean, dry area. PUMP MAINTENANCE & DISASSEMBLY To keep the pump working smoothly and efficiently, the plunger o-ring needs to be lubricated often by applying grease or petroleum jelly around the outside of the plunger o-ring. To lubricate the plunger o-ring on model numbers 1401M, 1402M and 1403M do the following: · Remove pump assembly from the tank. · Unlock the pump handle and pull it out as far as it will go. · With a flat blade screwdriver, push down on the tabs on each side of the pump. Pull up and the handle and the plunger assembly should come out of the pump cylinder. · To reassemble, insert the plunger assembly into the cylinder and snap the cap back into place. To lubricate the plunger o-ring on model numbers 1002Mo the following: · Remove pump assembly from the tank. · Unlock the pump handle and pull it out as far as it will go. · Lay a flat blade screwdriver in the slot below PRY . Bring the screwdriver handle down towards the bottom of the pump. This will pry the cap out and over the tab. Repeat this procedure on the other side of the pump cap. [. . . ] ROOT-LOWELL MANUFACTURING CO. 'S LIABILITY IS LIMITED SOLELY TO THE REPAIR OR REPLACEMENT OF THE NON-FUNCTIONING PRODUCT OR PART. EXCLUDES LIABILITY UNDER THIS WARRANTY FOR ANY AND ALL INCIDENTAL AND CONSEQUENTIAL LOSS OR DAMAGE. Some states do not allow limitations on how long an implied warranty lasts, or the exclusion or limitation of incidental or consequential damages, so these limitations or exclusions may not apply to you. This warranty gives you specific legal rights and you may have other rights which vary from state to state. [. . . ]