User manual RL FLO-MASTER 2501

[. . . ] DO NOT spray gasoline or other flammables. DO NOT leave sprayer in the sun. If your sprayer is equipped with our new poly flow control, please assemble according to the following instructions: 1. Be sure to first insert pink siphon tube into hose insert otherwise sprayer will not operate. Lubricate (with grease or petroleum jelly), the o-ring on the hose insert and slide into tank until fully seated. [. . . ] 11. Empty any remaining solution into a proper storage or disposal container. If the chemical is stored in the tank, it can clog the system as it dries and it can promote corrosion. 12. Clean the sprayer after each use to prolong its life. After using water based products rinse thoroughly with water, being sure to flush out hose and flow control. After spraying solvent or oil based products, follow chemical manufacturers' recommended cleaning procedures. 13. To store the sprayer, hang the tank upside down with the pump removed and the flow control locked "on". This allows for proper drainage and drying. 14. Check for worn or damaged parts frequently. !MAINTENANCE AND DISASSEMBLY: To keep the pump working smoothly and efficiently, the plunger u-cup seal needs to be lubricated often. Disassemble pump, according to the instructions below for your model, and apply grease or petroleum jelly around the outside of the plunger cup. Note: Your sprayer was lubricated at the time of manufacture. STRAIGHT NECK SPRAYER MODELS 2501, 2502, 2503: Place the pump assembly on the edge of the table as shown and pull with downward motion. The assembly will snap apart when the tank cap strikes the table. To reassemble, insert the plunger assembly into the pump cylinder, resting the tank cap on top of the pump cylinder. Turn the assembly upside down and tap firmly on a hard surface to snap pump assembly back into place. FUNNEL TOP SPRAYER MODELS 2601, 2602, 2602I, 2603, 1602: Lay pump down on table. With flat blade screwdriver, push in on the tabs on each side of the pump and pry down. Pull up on the handle and the plunger assembly should come out of the pump cylinder. To reassemble, insert plunger assembly into cylinder and push the tabs back into place. !TROUBLESHOOTING: Always depressurize the sprayer, remove chemical solution, and clean the sprayer before making repairs. Refer to the parts diagram for part numbers and names. Replacement parts may be purchased at most RL FLOMASTER dealers, or they can be ordered from our Consumer Service Hotline at 1-800-253-4642. PROBLEM: Pump works hard or does not pressurize tank. [. . . ] EXCLUDES LIABILITY UNDER THIS WARRANTY FOR ANY AND ALL INCIDENTAL AND CONSEQUENTIAL LOSS OR DAMAGES. Some states do not allow limitations on how long an implied warranty lasts, or the exclusion or limitation of incidental or consequential damages, so these limitations or exclusions may not apply to you. This warranty gives you specific legal rights and you may have other rights which vary from state to state. IF YOU HAVE QUESTIONS OR CONCERNS, PLEASE CALL OUR CONSUMER SERVICE HOTLINE AT 1-800-253-4642 (Monday through Friday, 8:00a. m. [. . . ]