User manual RL FLO-MASTER 3PC FLO-N-GO SPRAYER

[. . . ] DO NOT spray gasoline or other flammables. HOSE/FLOW CONTROL ASSEMBLY To insure complete insertion into tank, lubricate (use grease or petroleum jelly), the o-ring on the hose insert, then slide into tank until fully seated. Slide nut to threaded connection and securely screw onto tank. BE SURE TO FIRST INSERT SIPHON TUBE INTO HOSE INSERT OTHERWISE SPRAYER WILL NOT OPERATE. [. . . ] To prevent ejected pump assembly and/or solution from striking and injuring you, never stand with face or body over the top of the tank when pumping or loosening pump. 8. Empty any remaining solution into a proper storage container or disposal container. If the chemical is stored in the tank, it can clog the system as it dries and can promote corrosion. 9. Clean the sprayer after each use to prolong its life. After using water-based products, rinse thoroughly with water, being sure to flush out hose and flow control. After spraying solvent or oil-based products, follow chemical manufacturer's recommended cleaning procedure. To store the sprayer, hang the tank upside down with the pump removed and the flow control locked "on". This allows for proper drainage and drying. Check for worn or damaged parts frequently. MAINTENANCE AND DISASSEMBLY: be lubricated often. To open pump assembly: To keep the pump working smoothly and efficiently, the plunger u-cup seal needs to A B C D Uncsrew pump cap (B) and pull out plunger assembly (A) from cylinder (D). If the pump leaks at the tank opening: Clean or replace the cylinder gasket (C). If pump doesn't pressurize your sprayer: Lubricate the plunger cup (E) with petroleum jelly or replace. If pump won't pressurize and/or liquid gets in the pump: Clean or replace the check valve A. F. Plunger Assembly/Pump handle Pump Cap Cylinder Gasket Cylinder Assembly Plunger Cup Check Valve E F TROUBLESHOOTING: Always depressurize the sprayer, remove chemical solution, and clean the sprayer before making repairs. Refer to the parts diagram for part numbers and names. Replacement parts may be purchased at most RL FLOMASTER dealers, or they can be ordered from our Consumer Service Hotline at 1-800-253-4642. CAUSE: (1) Hose/tank screw connector loose OR (2) Hose damaged. SOLUTION: (1) Tighten screw connector - hand tighten only. OR (2) or replace with new hose/flow control assembly. CAUSE: (1) Extension o-ring prevented from sealing by dirt or damage OR (2) Extension nut not screwed in all the way on the flow control. SOLUTION: (1) Clean and examine o-ring, replace if damaged OR (2) Push extension into flow control until it snaps into place. Then screw extension nut into flow control. [. . . ] ANY IMPLIED WARRANTIES, INCLUDING THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR CONSUMER USE, ARE LIMITED TO THE DURATION SPECIFIED ABOVE. ROOT-LOWELL MANUFACTURING CO. 'S LIABILITY IS LIMITED SOLELY TO THE REPAIR OR REPLACEMENT OF THE NON-FUNCTIONING PRODUCT OR PART. EXCLUDES LIABILITY UNDER THIS WARRANTY FOR ANY AND ALL INCIDENTAL AND CONSEQUENTIAL LOSS OR DAMAGE. Some states do not allow limitations on how long an implied warranty lasts, or the exclusion or limitation of incidental or consequential damages, so these limitations or exclusions may not apply to you. [. . . ]