User manual RME RPMMAC

[. . . ] User's Guide Mac OS X Version Hammerfall® DSP System RPM TotalMix 24 Bit / 96 kHz ü SyncAlign ® TM ZLM ® Mobile Turntable / CD / MIC / MIDI Interface PCI Busmaster Digital I/O System PCI and CardBus Interface 24 Bit / 96 kHz Contents Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 System Requirements. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Brief Description and Characteristics. . . . . . . . . . . . . . . . . . . [. . . ] We will now create a small submix for the headphone output. Please start a multitrack playback and connect your headphones to the headphone output. In playback channel 1 (labeled 'Out 1'), click onto the routing window below the label. A list pops up, showing a checkmark in front of 'AN 1+2'. The list disappears, the routing window no longer shows 'AN 1+2', but 'Phones'. As soon as the fader value is unequal m. a. , the present state is being stored and routing is activated. The present gain value is displayed below the fader in green letters. In the lower row, on channels 5 and 6 (PH. L. and PH. R. ), you can also see the level of what you are hearing in the phones. The level meter of the hardware output shows the outgoing level. Click into the area above the fader and drag the mouse in order to set the panorama, in this case the routing between channels 5 and 6. The present pan value is also being displayed below the fader. Please carry out the same steps for 'Out 2' now, in order to route it to the headphone output as well. It is therefore helpful to be able to make the routing settings for two channels at once. Press the Ctrl-key and click into the routing window of 'Out 3' with the key pressed. The routing list pops up with a checkmark at 'AN 3+4'. Now, channel 4 has already been set to 'Phones' as well. When you want to set the fader to exactly 0 dB, this can be difficult, depending on the mouse configuration. Move the fader close to the 0 position and now press the Shift-key. This activates the fine-mode, which stretches the mouse movements by a factor of 8. In this mode, a gain setting accurate to 0. 1 dB is no problem at all. Please set 'Out 4' to a gain of around -20 dB and the pan close to center. [. . . ] RME's replacement service within this period is handled by the retailer. If you suspect that your card is faulty, please contact your local retailer. The warranty does not cover damage caused by improper installation or maltreatment - replacement or repair in such cases can only be carried out at the owner's expense. RME does not accept claims for damages of any kind, especially consequential damage. [. . . ]