User manual ROBLIN CUBIX DIMENSIONS

[. . . ] Clean and/or replace the Filters after the specified time period. Clean the hood using a damp cloth and a neutral liquid detergent. Ty Product Components 1 Hood Body, complete with: Controls, Light, Blower, Filters 1 Upper Chimney 1 Telescopic frame complete with extractor, consisting of: 1 Upper frame 1 Lower frame 1 Reducer Flange ø 150-120 mm 1 Damper 1 Gasket 1 Hood Body Air Outlet Extension Piece 1 Air Outlet Connection 2 Pipe clamps 1 Fixing Part of the upper Chimney 1 Air outlet connection tube Q. Dia washers M6 nuts Fixing knobs for the air outlet connection piece Use a plumb line to mark the centre of the hob on the ceiling/support shelf. [. . . ] For Cavity ceiling with inner space, with wall thickness of approx. For wooden beam ceilings, use 4 wood screws (not provided). For wooden shelf, use 4 screws 12g with washers 22 and nuts 23, provided. Unfasten the eight metric screws joining the two columns, located at the sides of the frame. Fix the Fixing Part of the Upper Chimney 26 to the hanging kit using the 2 screws 12w (M3 x 8). Lift up the frame, fit the frame slots onto the screws up to the slot end positions. Tighten the two screws and fasten the other two screws provided; before locking the screws completely, it is possible to adjust the frame by turning it, making sure that the screws do not come out of their housing in the adjustment slot. It is now possible to place and tighten the 4 safety screws, Proceed as follows: · Drill the ceiling with a 10 mm ø bit taking as reference the holes of the side parts of the upper chimney fixing part. The Frame must be securely fastened so as to support both the weight of the Hood and the stress caused by occasional axial pressure against the fitted Appliance. After fixing, make sure that the base is stable even when the Frame is subjected to lateral stress. If the Ceiling is not strong enough in the area where the hood is to be fixed, the Installer must strengthen the area using suitable plates and counterplates anchored to resistant structures. (Reset; check the Maintenance-paragraph) indicates that the activated charcoal odour filter saturation alarm has been triggered , and the filter has to be replaced; the metal grease filters must also be washed. The activated charcoal odour filter is triggered after 200 working hours. REMOTE CONTROL (OPTIONAL) The appliance can be controlled using a remote control powered by a 1. Do not place the remote control near to heat sources. Used batteries must be disposed of in the proper manner. Clean the outside using a damp cloth and neutral liquid detergent. Clean the inside as well using a damp cloth and neutral detergent; do not use wet cloths or sponges, or jets of water; do not use abrasive substances. When the above operation has been completed, hook the panel back to the hood canopy and close it by turning the knob in the opposite direction. Switch off the lights and extractor motor. Press button T3 for at least 3 seconds, until the leds start to flash. cleaning the filters · The filters are washable and must be cleaned when the LED S1 lights up or at least every 2 months of operation, or more frequently for particularly heavy usage. [. . . ] The filter is not washable and cannot be regenerated. It must be replaced when led S1 flashes or at least every 4 months. The alarm signal will only light up when the extractor motor is switched on. Disconnect the Hood using the Main switch or the double-pole switch on the mains power supply. [. . . ]