User manual ROBLIN DECLIC 609

[. . . ] Ensure the kitchen is fitted with an airbrick, which should have a cross-sectional measurement equivalent to the diameter of the ducting being fitted, if not larger. â· The ducting system for this cooker hood must not be connected to any existing ventilation system, which is being used for any other purposes or to a mechanically controlled ventilation ducting. â· The ducting used must be made from fire retardant materials and the correct diameter must be used, as incorrect sized ducting will affect the performance of this cooker hood. â· When the cooker hood is used in conjunction with other appliances supplied with energy other than electricity, the negative pressure in the room must not exceed 0. [. . . ] Cut the require aperture in the base of the kitchen cabinet as indicated (fig. Insert the telescopic extractor in the aperture in the kitchen cabinet and turning the screws clockwise secure the assembly to the kitchen cabinet (fig 1). Insert the grommets into the screw holes (fig 8). Connect the ducting onto the round outlet on the top of the motor assembly. Connect both appliances together (fig 9) and connect them to the mains supply (See ELECTRICAL WIRING chapter). CAUTION : If the kitchen cabinet does not have a door you must execute points 6 and 7 before point 4. C - REPLACING THE DECORATIVE FRONT STRIP You can replace the strip in the front trim with a matching strip of kitchen furniture finish or with a complete piece of cornice. When replacing the front strip with matching laminate. Firstly, remove the right-hand end capping from the front trim and slide out the aluminium front strip plate. secondly , insert the cut piece of laminate and replace the right-hand end capping. When replacing the whole front trim with a piece of lighting pelmet or similar. firstly , remove the righthand end capping and the aluminium strip to access to the front fixing screws. Secondly, cut the new front trim in accordance with the dimension contained in fig. 14 and machine finish the new strip before fixing the trim and metal plate using the original screws (fig. To obtain the best performance it is advisable to switch `ON' the cooker hood a few minutes (in the boost setting) before you start cooking and you should leave it running for approximately 15 minutes after finishing. Do not leave frying pans unattended during use as over-heated fat and oil might catch fire. â· Do not leave naked flames under this cooker hood. Ensure heating areas on your hotplate are covered with pots and pans when using the hotplate and cooker hood simultaneously. Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply. The cooker hood must be kept clean; a build up of fat or grease can be a fire hazard. [. . . ] The wire which is coloured brown must be connected to the terminal which is marked with the letter `L' or coloured red. Before connecting to the mains supply ensure that the mains voltage corresponds to the voltage on the rating plate inside the cooker hood. This appliance is fitted with a 2 core mains cable and must be permanently connected to the electricity supply via a double-pole switch having 3mm minimum contact gap on each pole. 1363 Part 4, fitted with a 3 Amp fuse, is a recommended mains supply connection accessory to ensure compliance with the Safety Requirements applicable to fixed wiring instructions. [. . . ]