Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual ROBLIN DUNE XLS. We hope that this ROBLIN DUNE XLS user guide will be useful to you.
Lastmanuals help download the user guide ROBLIN DUNE XLS.
Detailed instructions for use are in the User's Guide.
[. . . ] Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood. The route of the flue must be as short as possible. [. . . ] 1 on the wall as shown at X mm below the first bracket (X = height of the upper chimney section supplied), aligning the centre (notch) with the vertical line. REAR PANEL (OPTIONAL) The Rear Panel must be fitted before fixing the hood body and, for both upper an lower positiion fixing, must be fitted at the correct height prior to installing the bases. As this operation is rather complex, it should be carried out either by the kitchen installer or a qualified person who knows the final dimensions of the units. for the upper fixing position , proceed as follows: · Rest the back panel on the base, inserting the lower plate between the upper surface and the wall, centring it on the vertical reference line. Fix the brackets using the 12a screws (4, 2 x 44, 4) supplied. Fix the back panel (where present) using the 12a (4, 2 x 44, 4) screws supplied. Before hooking up the hood body, adjust the two screws Vr located on the hood body connection points so that they are at the half way point. DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. Fix the pipe in position using sufficient pipe clamps (not supplied). Push fit connection 15 onto the hood body outlet. Make sure that the outlet of the extension pieces 14. 1 is horizontally and vertically aligned with the chimney outlets. If this is not the case, adjust the position by either reversing the connection extension pieces 14. Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. [. . . ] Unscrew the bulbs and replace them with new ones having the same characteristics. Remove the snap-on lamp cover by levering it from under the metal ring, supporting it with one hand. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE ROBLIN DUNE XLS
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual ROBLIN DUNE XLS will begin.
