User manual ROBLIN GRAPHIC 900 DIMENSIONS

[. . . ] mAINTENANCE · Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. ⷠClean and/or replace the Filters after the specified time period. ⷠClean the hood using a damp cloth and a neutral liquid detergent. Ty Product Components 1 Hood Body, complete with: Controls, Light, Blower, Filters 1 Upper Section (optional) 1 Lower Section (optional) 1 Directional Air Outlet grille 1 Flange (optional) 1 Angle iron (optional) 1 Filter cover On the wall, draw · A Vertical line up to the ceiling or upper limit, at the centre of the area in which the Hood is to be fitted; · A Horizontal line at a minimum of 960 mm above the Cooker Top. [. . . ] Repeat this operation on the other side, checking that the two marks are level. ⷠMark a reference point (2) as indicated at 180 mm from the vertical reference line and 362 mm above the Cooker Top. ⷠRepeat this operation on the other side, checking that the two marks are level. Insert the bracket plugs 11a into the holes 1 and screw into place. 1 on the wall as shown about 1-2 mm from the ceiling or upper limit aligning the centre (notch) with the vertical reference line. 1 on the wall as shown at X mm below the first bracket (X = height of the upper chimney section supplied), aligning the centre (notch) with the vertical line. Fix the brackets using the 12a screws (4, 2 x 44, 4) supplied. Hook the hood canopy onto the two brackets 11a. DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe, the choice of which is left to the installer. Fix the pipe in position using sufficient pipe clamps (not supplied). (Reset; check the Maintenance-paragraph) indicates that the activated charcoal odour filter saturation alarm has been triggered , and the filter has to be replaced; the metal grease filters must also be washed. The activated charcoal odour filter is triggered after 200 working hours. REMOTE CONTROL (OPTIONAL) The appliance can be controlled using a remote control powered by a 1. Do not place the remote control near to heat sources. ⷠUsed batteries must be disposed of in the proper manner. Switch off the lights and extractor motor. ⷠPress button T3 for at least 3 seconds, until the leds start to flash. cleaning the filters · The filters are washable and must be cleaned when led S1 flashes or at least every 2 months of operation, or more frequently for particularly heavy usage. ⷠRemove the filters one at a time by pushing them towards the back of the group and pulling down at the same time. ⷠWash the filters, taking care not to bend them. [. . . ] ⷠRemove the filters one at a time by pushing them towards the back of the group and pulling down at the same time. ⷠWash the filters, taking care not to bend them. ⷠWhen refitting the filters, make sure that the handle is visible on the outside. Clean the outside using a damp cloth and neutral liquid detergent. [. . . ]