User manual ROBLIN LAGOON 900 DIMENSIONS

[. . . ] Insert the two screws 12a (4, 2 x 44, 4) supplied in the hood body fixing holes, leaving a gap of 5-6 mm between the wall and the head of the screw. Before attaching the hood body, tighten the two screws Vr located on the hood body mounting points. DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120mm, the choice of which is left to the installer. [. . . ] Fix the pipe in position using sufficient pipe clamps (not supplied). Fix the pipe in position using sufficient pipe clamps (not supplied). Put connection 15 into the connection support 7. Make sure that the outlet of the extension pieces 14. Connect the air outlet connection 15 to the hood body outlet using either a flexible or rigid pipe ø 150 mm, the choice of which is left to the installer. Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. Slightly widen the two sides of the upper flue and hook them behind the brackets 7. 1, making sure that they are well seated. Make sure that the outlet of the extensions pieces is aligned with the chimney outlets. cleaning the filters · The filters are washable and must be cleaned when the LED S1 lights up or at least every 2 months of operation, or more frequently for particularly heavy usage. Remove the filters one at a time by pushing them towards the back of the group and pulling down at the same time. Wash the filters, taking care not to bend them. When refitting the filters, make sure that the handle is visible on the outside. The filter is not washable and cannot be regenerated. It must be replaced when led S1 flashes or at least every 4 months. The alarm signal will only light up when the extractor motor is switched on. Disconnect the Hood using the Main switch or the double-pole switch on the mains power supply. All five LEDs are turned on · Within 3 seconds press T1 until LEDs T1 and T4 flash in confirmation: LED flashes twice - Activated charcoal filter saturation alarm ENABLED LED flashes once - Activated charcoal filter saturation alarm DISABLED Switch off the lights and extractor motor. [. . . ] All five LEDs are turned on · Within 3 seconds press T1 until LEDs T1 and T4 flash in confirmation: LED flashes twice - Activated charcoal filter saturation alarm ENABLED LED flashes once - Activated charcoal filter saturation alarm DISABLED Switch off the lights and extractor motor. Press button T3 for at least 3 seconds, until the leds start to flash. Fit the new filter by hooking it into its seating · Remove the snap-on lamp cover by levering it from under the metal ring, supporting it with one hand. [. . . ]