User manual ROBLIN LIDO DESIGN 900 DIMENSIONS

[. . . ] - Use the high extraction speed for normal use. - When producing large quantities of steam during cooking, use the high extraction speed and keep the hood operating after finishing cooking (about 15 or 30 minutes). For your safety, and to respect our guarantee conditions: - Do not connect the hood to smoke or extraction ducts already being used. - Check that the mains voltage is the same as the values stated on the identification plate inside the hood. [. . . ] Before carrying out any work (cleaning changing filters - lighting), switch the appliance off by pulling the plug out if you can reach it, or by switching the circuit breaker off. The metal grease filter should be cleaned every two months with normal usage and can be cleaned in a dishwasher or by hand using a mild detergent or liquid soap. When replacing, ensure that the handle faces outwards. NOTE: new grease filters can be obtained from your dealer. - This filter cannot be cleaned, and therefore must be replaced at a frequency which depends on the frequency of use (about twice per year). Use lukewarm water only, to which a non-aggressive cleaning liquid is added. If you request assistance from your After Sales Service, you should inform them of the characteristics stated on the identification plate close to the motor in your hood (model - type - serial number). This is why our guarantee is applicable exclusively and soley to appliances which have been installed and connected by yourself, in accordance with the requirements of ordinances in force. You will be responsible if this condition is not respected. - The hood must always be fitted above the center of the cooker hob. - The minimum distance between the top of the cooker hob and the bottom of the hood shall be 650 mm. There is an adjustment lever inside the hood (fig. 4) for selecting "evacuation" or "recycling" (accessible after removing the grease filters). - Lever down - recycling (air outlet by front upper louvers). - Lever up - evacuation (outlet through rear duct). These positions must be respected in accordance with the selected use. - Connect the hood to an individual or collective duct (unused flue) using pipes and connection pieces made of uninflammable material. - When the evacuation version hood is used, it must not hinder existing ventilation or extraction, and must be in accordance with Unified Technical Document DTU n° 61-1. - Connection fittings must be made in accordance with standard practice and respect safety conditions, and under no circumstances shall the evacuation duct discharge into the attic. - Flues used as smoke ducts shall not be used. - In this case, it is recommended that the telescopic suction cup reference AH 4009 F1 with built in non-return valve be used (fig. - This square suction cup was specially designed for hoods and can be built into any outside wall between 23 and 43 cm thick. [. . . ] - Put the adjustment lever to the recycling position (down) and after installing the active carbon filter (as described in the installation part of these instructions and in accordance with the instructions attached to the recycling kit) the recycled air is discharged through the louvers at the top of the hood facade. - In this case the hood must be drawn fully down to completely free the facade louvers. - Lift the auvent by its lower part and insert the two upper guide-slides in their respective housings. - Pivot the auvent downwards inserting the two lower guide-slides and tilt the auvent until it closes. [. . . ]