User manual ROBLIN N KHAN 900 DIMENSIONS

[. . . ] Accordingly, you may find descriptions of individual features that do not apply to your specific appliance. 1 ELECTRICAL · This cooker hood is fitted with a 3-core mains cable with a standard 10/16A earthed plug. Alternatively the hood can be connected to the mains supply via a double-pole switch having 3mm minimum contact gap on each pole. Before connecting to the mains supply ensure that the mains voltage corresponds to the voltage on the rating plate inside the cooker hood. [. . . ] 6) Aligning its centre on the vertical line, mark the 4 eyelet holes of the upper canopy bracket onto the wall about 448 mm from the ceiling or from the upper limit. drill the holes for the fixing bracket using an 8 mm masonry bit. 7) Fixing the canopy: Before starting to fix the canopy it will be necessary to follow the instructions Fig. 650 mm when fitting above an electric hotplate and 700 mm when fitting above a gas hotplate. select the height required using the measurements illustrated in Fig. 9 and fix the metal diffuser to the frame of the chimney brackets using the height 5 x 10T hexagonal headed screws. a drawing on the drill gauge defines the positioning for the controls. 8) Place the canopy onto the wall brackets and fix it to the ceiling as illustrated in Fig. Attention: 2 persons are necessary to secure this operation. 10) Ducting: The hood is more effective when used in the extraction mode (ducted to the outside). When the cooker hood is ducted to the outside, charcoal filters are not required. You should keep applying pressure to the `+' and `-` button until the required speed is selected. It is advisable too that you should leave it running in the boost setting for approximately 5 minutes after finishing. Pre-set stop of the boost speed : A pre-set stop after 5 minutes of the boost speed is available. Your cooker hood is supplied with a deactivated pre-set stop of the boost speed. To use the cooker hood with a pre-set stop of the boost speed re-programme the hood as follows: The lights and the fan motor should be switched `OFF' to set the timer. Push the LED button `-' until the LED lights will flash : One flash of the LED lights 2, 3, and 4 = function is switched `OFF'. Two flashes of the LED lights 2, 3, and 4 = function is switched `ON'. While the 5 minutes timer is running, It is available to stop immediately the boost speed by pressing the led button 5. While the 5 minutes timer is running, the indication of saturation of the filters is switched `OFF'. If a pre-set stop for the hood is switched `ON' and the 5 minutes timer is still running, the boost speed will be switched `OFF' together with the pre-set stop for the hood after the count down of 5, 10 or 15 minutes. It is available to stop the boost speed before the count down of the preset stop of the hood by pressing the led button 5. [. . . ] 5 USEFUL HINTS · To obtain the best performance we recommend you to switch `ON' the cooker hood a few minutes (in the boost setting) before you start cooking and you should leave it running for approximately 15 minutes after finishing. IMPORTANT: NEVER DO FLAMBÉ COOKING UNDER THIS COOKER HOOD Do not leave frying pans unattended during use as over-heated fat and oil might catch fire. Do not leave naked flames under this cooker hood. switch `OFF' the electric and gas before removing pots and pans. [. . . ]