User manual ROBLIN OPEN 610

[. . . ] - Preferably use the cooking areas at the back of your appliance. - Operate the hood for a few minutes before starting cooking. - Use low speed for simmering and dishes which produce little steam. [. . . ] - Use the template to position the support lug wall attachment holes and drill the holes for the plugs (top edge of the hood aligned with the top of adjacent furniture). - Attach the support lugs with appropiate screws. - The hood depth can be adjusted between 27 and 36 cm. 1 - Measure the body depth of the furniture between which the hood is to be installed. 2 - Loosen the hexagonal bolts for the adjustment of the upper suspension hooks (fig. 8), pull the hooks to the correct dimension and retighten the bolts. 3 - Loosen the lower spacer plate support bolts (fig. 9) , pull it to the right dimension and retighten the bolts. This square spacer plate with built in unequal ribs can be reversed depending on the required depth. - This hood must be fitted with a facade similar to that for the furniture in the kitchen and fixed to the auvent (facade supplied by the furniture installer). 1 - Fully open the auvent and press the locking key at the front left inside (fig. 2 - Drill the starter holes inside the facade using the drilling template provided for this purpose. 3 - Place the auvent on the panel aligning the holes and screw in using the screws provided. Do not put it back on the hood before installation on the wall. - Attach the hood by its suspension hooks to the support lugs attached to the wall. - To prevent accidental separation, drill and attach the two safety brackets (supplied with the appliance) to the wall so that they bear on the suspension hooks. - If necessary, adjust the alignment with the adjacent furniture using the suspension hook adjustment bolts (fig. - Remove the filter support grillage and use the holes visible in the side walls to attach to adjacent furniture. [. . . ] - Depending on the weight of the facade, the friction resistance of the auvent may be adjusted from the inside by means of screws located at the front corners of the appliance (fig. - If necessary, make a final alignment with the adjacent furniture by adjusting the auvent screws supporting the facade. - Connect the appliance cord to a 10/16 A standard grounded power outlet (2 pins + earthing pin), preferably located above the hood. [. . . ]