User manual ROBLIN ORELIA S

[. . . ] The minimum safety distance between the cooker top and the extractor hood is 650 mm. Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood. [. . . ] Draw a horizontal line at 650 mm above the hob. 1 on the wall as shown about 1-2 mm from the ceiling or upper limit. 1 on the wall as shown at X mm below the first bracket (X = height of the upper chimney section supplied). 1 on the wall as shown at 357 mm above the horizontal reference line, making sure that the holes used to fix the corner to the wall are equidistant. Fix the brackets and the Support using the 12a (4, 2 x 44, 4) screws supplied. Insert the two screws 12r (4, 2 x 12, 7) supplied in the hood body fixing holes, located on the front plate of the Hood Connector Support, leaving a gap of 5-6 mm between the Support and the head of the screw. Before attaching the hood body, tighten the two screws Vr located on the hood body mounting points · Adjust screws Vr to level the hood body DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. Fix the pipe in position using sufficient pipe clamps (not supplied). Push fit connection 15 onto the air outlet. Make sure that the outlet of the extension pieces 14. If this is not the case, adjust the position by either reversing the connection extension pieces 14. Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. [. . . ] Fit the new filter by hooking it into its seating. Remove the 2 Screws fixing the Lighting support, and pull it out of from the Hood. [. . . ]