User manual ROBLIN PALMA MURALE

[. . . ] Thank you for buying a Roblin product which has been manufactured to the highest quality standards to meet your requirements. We recommend you carefully read this booklet in which you will find instructions for installation, hints for use and maintenance. The Instructions for Use apply to several versions of this appliance. Accordingly, you may find descriptions of individual features that do not apply to your specific appliance. [. . . ] Before fitting the chimney to the canopy make the electrical connection as described in the section titled ELECTRICAL. When the electrical connection has been made, test the lights and the fan motor. Each chimney stack consists of two sections. encase the upper section in the telescopic bottom section (Fig. 1 - item 7a & b) by making it exceed at least 150 mm, maintain it in this position with an adhesive tape (in order to avoid scratches between the 2 sections). Place slightly the chimney on the canopy and fit the upper sections by expanding the chimneys to allow them to clamp around the bracket item 2 and secure the chimney stacks to the brackets using the two M4 screws item 12c provided. Attention scratches risk on the junction line of the canopy with the lower chimney. Not remove the film from the canopy before the complete fitting of the chimney. Fit the recirculation spigot R onto the upper chimney wall bracket using the same fixing screws (Fig. Connect the ducting 150mm (6 INS) not provided between motors item 6 and the recirculation spigot and secure the connections with appropriate clamping rings or adhesive tape. Before fitting the chimney to the canopy make the electrical connection as described in the section titled ELECTRICAL. When the electrical connection has been made, test the lights and the fan motor. Insert the charcoal filter into the base of the motor housing and secure the filter with two metal securing straps item A as illustrated in Fig. Each chimney stack consists of two sections. encase the upper section in the telescopic bottom section (Fig. 1 - item 7a & b) by making it exceed at least 150 mm, maintain it in this position with an adhesive tape (in order to avoid scratches between the 2 sections). Place slightly the chimney on the canopy and fit the upper sections by expanding the chimneys to allow them to clamp around the bracket item 2 and secure the chimney stacks to the brackets using the two M4 screws item 12c provided. Attention scratches risk on the junction line of the canopy with the lower chimney. Not remove the film from the canopy before the complete fitting of the chimney. To use the cooker hood in the recycling mode re-programme the hood as follows: Starting in the recycling mode (the contaminated air passes into the hood through the grease filters and the purifying activated charcoal filter and back out into the kitchen through grilles). Press the `+' button (while the motor and lights are switched `OFF') until the five LED lights will flash twice to indicate confirmation that the cooker hood is in the recycling mode. reverting to the extraction mode (The cooker hood is ducted to the outside). [. . . ] The filter should be replaced at least every three months or more frequently if the hood is used for more than three hours per day. Press against the two retaining clips, which hold the charcoal filter in place and this will allow the filter to drop down and be removed. â· Clean the surrounding area and metal grease filters as directed above. â· Insert the replacement filter and ensure the two retaining clips are correctly located. [. . . ]