User manual ROBLIN QUARTZ 610

[. . . ] If the room where the hood is to be used contains a fuel-burning appliance such as a central heating boiler then its flue must be of the room sealed or balanced flue type. ⷠIf other types of flue or appliances are fitted ensure that there is an adequate supply of fresh air to the room. Ensure the kitchen is fitted with an airbrick, which should have a cross-sectional measurement equivalent to the diameter of the ducting being fitted, if not larger. ⷠThe ducting system for this cooker hood must not be connected to any existing ventilation system, which is being used for any other purposes or to a mechanically controlled ventilation ducting. [. . . ] ⷠRECIRCULATION In the recirculation mode (with the optional activated charcoal filter fitted) the contaminated air enters thehood through the grease filter and through the purifying activated charcoal filters and back out into thekitchen through a grille in the front of the kitchen cabinet (fig. Before the charcoal filter can be fitted it is necessary to fix the propeller shaped bracket over outlet in thebody of the canopy using the 3 No M4 x 6 screws provided and then the activated charcoal cartridge can be fitted (fig 10). B - REMOTE INSTALLATION OF THE QUARTZ WITH CONFORT PRO OR MISTRAL 800 MOTOR See the specific instruction booklet supplied when fitting the remote controlled Confort Pro or Mistral 800 motor at a distance from the Quartz extractor hood. Cut the required aperture in the base of the kitchen cabinet as indicated (fig. Insert the extractor in the aperture in the kitchen cabinet and turning the screws clockwise secure theassembly to the kitchen cabinet (fig 6). Connect the ducting onto the round outlet on the top of the Quartz extractor. Connect both appliances together (fig 8) and connect them to the mains supply (See ELECTRICAL WIRING chapter). CAUTION : If the kitchen cabinet does not have a door you must execute points 5 and 6 before point 3. To obtain the best performance we recommend you to switch `ON' the cooker hood a few minutes (in the boost setting) before you start cooking and you should leave it running for approximately 15 minutes after finishing. Do not leave frying pans unattended during use as over-heated fat and oil might catch fire. Do not leave naked flames under this cooker hood. switch `OFF' the electric and gas before removing pots and pans. Ensure heating areas on your hotplate are covered with pots and pans when using the hotplate Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply. The cooker hood must be kept clean; a build up of fat or grease may cause a fire hazard. casing · Wipe the cooker hood frequently with a clean cloth, which has been immersed in warm water containing a mild detergent and wrung out. ⷠNever use excessive amounts of water when cleaning particularly around the control panel. Always wear protective gloves when cleaning the cooker hood. Metal Grease Filters : The metal grease filters absorb grease and dust during cooking in order to keep clean the cooker hood inside. The grease filters should be cleaned once a month or more frequently if the hood is used for more than 3 hours per day. active Charcoal Filter : The charcoal filter cannot be cleaned. [. . . ] The correct disposal of your old product will help prevent potential negative consequences for the environment and human health. Any permanent electrical installation must comply with the latest I. For your own safety this should be undertaken by a qualified electrician e. Your local Electricity Board, or a contractor who is on the roll of the National Inspection Council for Electrical Installation Contracting (NICEIC). [. . . ]