User manual ROCKTRON HUSH2000

[. . . ] is properly adjusted and setup (follow all instructions). Extra care and caution should be taken to avoid tip over and injury. Unplug this apparatus during lightening storms or when unused during long periods of time. Refer all service to qualified service personnel. [. . . ] POWER Switch - Pressing this button will turn "on" the MIDI XChange. Pressing the button again will turn "off" the MIDI XChange. Upon turning the unit on the display (see point 1) will begin to flash the number "1". At this point you may either press the RECALL switch to select preset "1" or use the UP and DOWN buttons to select the desired preset number. Press the RECALL button to choose the selected preset. CC17 Jack (CONTINUOUS CONTROLLER 17 Jack) This jack will allow you to plug in a Rocktron HEX Volume/ Expression pedal to control various parameters via MIDI (see HOW TO USE THE CC17 AND CC7 PORTS for details on how to operate this simple to use function). CC7 Jack (CONTINUOUS CONTROLLER 7 Jack) This jack will allow you to plug in a Rocktron HEX Volume/ Expression pedal to control various parameters via MIDI (see HOW TO USE THE CC17 AND CC7 PORTS for details on how to operate this simple to use function). 2 3 4 5 MIDI OUT Jack - This Jack is used to connect to various MIDI devices. Using a standard 5-Pin MIDI Cable or the Rocktron RMM900 7-Pin MIDI Cable connect from this jack to the "MIDI IN" on the receiving MIDI device. (See the CONNECTIONS sections for details on how to connect up to various MIDI devices). Note - this is a 7-Pin jack, but a standard 5 pin MIDI cable may be used. However, you may use the Rocktron RMM900 7-Pin to 7-Pin MIDI Cable to receive phantom power from select Rocktron units that will provide power to the MIDI XChange. 6 DOWN Switch - This switch will allow you to scroll down to the desired preset. This indicates that preset number 1 is selected as shown below: UP, DOWN and RECALL Switches These switches will allow you to change presets or MIDI channels. The range is 1-128 for the presets and 1-16 for the MIDI Channels. For details on changing the MIDI channel see section titled SETTING MIDI CHANNEL for more details on this function. UP Switch - Depressing and releasing this switch once will increase the preset number by one. Depressing and holding the switch down will engage the automatic increment feature of the MIDI XChange. The MIDI XChange will now begin scrolling up through the preset numbers. After 4 increments the increment speed will increase allowing faster preset navigation. DOWN Switch - Depressing and releasing this switch once will decrease the preset number by one. Depressing and holding the switch down will engage the automatic decrement feature of the MIDI XChange. The MIDI XChange will now begin scrolling down through the preset numbers. After 4 decrements the decrement speed will increase allowing faster preset navigation. [. . . ] CC stands for CONTINUOUS CONTROLLER. HOW TO USE THE CC17 and CC7 PORTS: Connections - when using the Rocktron HEX Volume/Expression pedal use a stereo to stereo 1/4 jack cable (not included). When using a pedal other than the HEX you wil need two mono 1/4 male jacks to a RTS1/4 stereo male Y-Cord - there are several different kinds of expression pedal cables a few are shown below: CC17 Port - This controller port is the default volume controller for all Rocktron products. Thus, all you need to do to control the volume of each preset is plug an expression pedal into this port and it will control the volume on all Rocktron products. CC7 Port - This controller port is the default volume controller for most non-Rocktron products. [. . . ]