User manual ROCKTRON PROGAPV2

[. . . ] If an adapter is used take care to use an approved adapter and follow the instructions provided with the adapter. Protect the adapter cord from being walked on or pinched. Only used attachments/accessories specified by the manufacturer. Do not use this product with any case, stand tripod, bracket or table that is not specified by the manufacturer. [. . . ] Do not use this product with any case, stand tripod, bracket or table that is not specified by the manufacturer. Insure that the case, stand, tripod, bracket etc. is properly adjusted and setup (follow all instructions). Extra care and caution should be taken to avoid tip over and injury. Unplug this apparatus during lightening storms or when unused during long periods of time. Precautions Continued. . . . Refer all service to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power supply or plug is damaged, liquid has been spilled or objects have fallen into the apparatus or if the apparatus has been exposed to rain or moisture, does not operate normally or has been dropped. DO NOT ATTEMPT TO SERVICE THIS EQUIPMENT. THIS EQUIPMENT SHOULD BE SERVICED BY QUALIFIED PERSONNEL ONLY. DO NOT MAKE ANY INTERNAL ADJUSTMENTS OR ADDITIONS TO THIS EQUIPMENT AT ANY TIME OR TAMPER WITH INTERNAL ELECTRONIC COMPONENTS AT ANY TIME. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY VOID THE WARRANTY OF THIS EUQIPMENT AS WELL AS CAUSEING A SHOCK HAZARD. For example, if the input signal were to drop below the threshold point by 10dB, the output would drop approximately 12dB. As the input signal drops further below the threshold point, downward expansion increases exponentially. This means that if the input signal dropped 20dB below the threshold point, the output level would drop approximately 30dB. A 30dB drop below the threshold would result in a drop of 60dB of the output signal (30dB of gain reduction). The absence of any input signal will result in the expander reducing the gain so that the noise floor is inaudible. The Variable Integrated Release (V. I. R. ) technology contained in each HUSH circuit automatically adjusts the release rate of the expander based on the dynamic decay rate of the incoming signal. If the input signal stops suddenly, downward expansion will occur rapidly (similar to a gate). If the input signal decays slowly, expansion will occur slowly without disrupting the dynamic decay of the input signal. The THRESHOLD control should be adjusted by listening to the noise floor while not playing. Turn the THRESHOLD control clockwise to the point where the noise floor becomes inaudible. Turning too far past this point will cause the downward expander to attenuate the output level too quickly and not allow the signal to decay as long as it should. Functions Right Side 1 2 3 4 Left Side 5 6 7 8 1= This switch activates the HUSH circuitry. [. . . ] The THRESHOLD control should be adjusted by listening to the noise floor while not playing. Turn the THRESHOLD control clockwise to the point where the noise floor becomes inaudible. Turning too far past this point will cause the downward expander to attenuate the output level too quickly and not allow the signal to decay as long as it should. Functions Right Side 1 2 3 4 Left Side 5 6 7 8 1= This switch activates the HUSH circuitry. Step on the switch again to deactivate the HUSH. [. . . ]