User manual ROCKTRON PROQ

[. . . ] Keep these instructions Heed all warnings Follow all instructions. Clean with dry cloth Copyright © 2003 GHS Corporation All Rights Reserved. Precautions Continued. . . . Do not block any ventilation openings (if applicable). Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. [. . . ] This product is not equipped with a plug or cable. This pedal runs on a 9 Volt Battery, if a 9Volt DC adapter is the used please follow adapter manufacturer's operation instructions. Only used attachments/accessories specified by the manufacturer. Do not use this product with any case, stand tripod, bracket or table that is not specified by the manufacturer. Insure that the case, stand, tripod, bracket etc. is properly adjusted and setup (follow all instructions). Extra care and caution should be taken to avoid tip over and injury. Unplug this apparatus during lightening storms or when unused during long periods of time. Refer all service to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power supply or plug is damaged, liquid has been spilled or objects have fallen into the apparatus or if the apparatus has been exposed to rain or moisture, does not operate normally or has been dropped. Turning the control counter-clockwise decreases the volume. Tone Control - Adjusts the EQ range of the overdrive. Turning the control clockwise increases the "high-end" or "brightness" of the EQ. Turning the control counter-clockwise increases the "low-end" or "warmth" of the overdrive. Active LED - When lit the pedal is "active" or "on" Gain Control - Adjusts the amount of distortion added to the signal . Turning the control clockwise increases the saturation of the distortion. Turning the control counter-clockwise decreases the saturation of the distortion. 2 3 4 Bottom Left Side Right Side 5 Output Jack - Using a standard guitar cable with a 1/4" jack, plug into the input of your guitar amplifier or next stomp box On/Off Switch - This switch determines whether the pedal is "active" or "bypassed" - When "active" the blue LED will be lit. When bypassed the LED will not be lit Input - Using a standard guitar cable with a 1/4" jack, plug your guitar into this jack. DC 9V Input - To use external power (not provided) use only a 9-Volt DC adapter 9-Volt Battery Compartment - to access pull on small tab labeled "OPEN". Always remember to unplug your guitar cords from the pedal to conserve battery life. [. . . ] Always remember to unplug your guitar cords from the pedal to conserve battery life. Some battery drain may take place when unit is plugged in (even if the unit is bypassed). 6 7 8 9 Specifications Maximum Input Input Impedance Current Consumption Power Requirements Hints and Tips: +10dBu 1M ohm 35ma 9VDC <=300ma * CE Approved * An overdrive pedal is really the "secret tool" of many guitar players. Ever wonder how a guitar player can make a guitar with 3 single coils sound "huge" and sustain for days?Usually they have an overdrive pedal doing the work! [. . . ]