User manual ROCKTRON RB100

[. . . ] Instruction Manual Your Rocktron RB100 Bass Amplifier has been tested and complies with the following Standards and Directives as set forth by the European Union: Standard(s): IEC60065 Professional Audio/Video or Similar Equipment, EN55013:1997, EN61000-3-2 (1995) EN61000-3-3(1995), EN55020:1995, CSA E65-94 This means that this product has been designed to meet stringent guidelines on how much RF energy it can emit, and that it should be immune from other sources of interference when properly used. Improper use of this equipment could result in increased RF emissions, which may or may not interfere with other electronic products. To insure against this possibility, always use good shielded cables for all audio input connections. [. . . ] FAILURE TO FOLLOW THESE INSTRUCTIONS MAY VOID THE WARRANTY OF THIS EQUIPMENT, AS WELL AS CAUSING SHOCK HAZARD. OPERATING TEMPERATURE Do not expose this unit to excessive heat. This unit is designed to operate between 32° F and 104° F (0° C and 40° C). This unit may not function properly under extreme temperatures. Front Panel 1 Input Jacks - HIGH & LOW Using a standard guitar cable with a 1/4" jack - plug your bass into either jack. Select the HIGH input for added "gain" or the LOW input for a smoother - softer gain structure. GAIN Control The control adjusts the overall "GAIN" or distortion of the signal. TREBLE Control This controls adjust the "high" frequencies of the sound. MIDDLE - FREQUENCY & LEVEL Controls The FREQUENCY control knob adjusts the midrange EQ sweep. The LEVEL control will adjust the overall output of the frequency. This is a very useful feature which will allow you to dial in all sorts of tones!BASS Control This control adjusts the low-end frequency of the signal. MASTER VOLUME Control This control adjusts the overall output of the amplifier. LINE OUT Jack Use this jack for recording, direct to a PA system, or to a power amplifier HEADPHONE Jack This 1/4" jack is used to connect to stereo headphones. Plugging into this automatically mutes the speaker. This can also be used for direct recording as well in situations where you want to mute the speaker while recording. [. . . ] Using a small screw driver, open the fuse tray by prying open the small tab as shown in the drawing above. Please note that the tray will not come all of the way out. Remove the old fuse and replace with a comparable new fuse and close the tray being sure that the tray snaps into position AC 117V 50/60 HZ Fuse T1A 250V AC 230V 50/60 HZ Fuse T500mA 250V Check out some of our other products: Rack Gear: Gainiac (preamp w/12ax7 tube) Chameleon 2000 (preamp w/multi-effects) Voodu Valve (preamp w/12ax7 tube and multi-effects) Prophesy (our top of the line preamp with multi-effects) Intellifex On Line (Multi-effects processor) HUSH Super C (guitar noise silencing system) Vendetta VP4 Preamp (All Tube 4-Channel Guitar preamp - 2 Rack Space) Stomp Boxes: Rampage Distortion, Tsunami Chorus, Austin Gold Overdrive, HUSH The Pedal, Banshee Talkbox, Vertigo Vibe Electric Guitar - Acoustic Guitar and Bass Amplifiers: Vendetta Head(100 W Head 4-Channels All Tube - MIDI Switchable) Vendetta Combo (100W 2x12" Combo - Celestion 90's all Tube -4-Channel - MIDI Switchable) R80DSP (80W 1x12" Amp w/Digital Effects) RT80 (80W 1x12" Amp w/Reverb & Built-in Tuner) R120DSP (120W 2x10" Amp w/Digital Effects) R120C (120W 2x10" Amp w/Stereo Chorus and Reverb) RT122C (120W 2x12" Amp w/Stereo Chorus, Reverb & Chromatic Tuner) R50DSP (40 Watt 2x8"Guitar Amp w/Digital Effects) R50C (40 Watt 2x8"Guitar Amp w/Reverb & Chorus) R20 (20 Watt 1x8"Amp w/Reverb) R10 (10 Watt 1x6. 5") ACOUSTIC (60 Watt Acoustic Amp with Chorus & Reverb) RA50DSP (50W Acoustic Amp w/Digital Effects - Wedge Shape) RA30DSP (30W Acoustic Amp w/Digital Effects - Wedge Shape) RB20 (Basss Amp 20W with 8" Speaker) RB30 (Bass Amp 30W with 10" Speaker) RB60 (Basss Amp 60W with 12" Speaker) Foot Controllers: MIDI Mate (Midi Foot Controller) All Access (Midi Foot Controller MIDI XChange (MIDI Footcontroller) RMM900(7-pin Din MIDI Cable) RFS1 and RFS2 (Single and Double Latching Footswitchs for Rampage Amps) Rocktron - A Division of GHS Corporation 2813 Wilber Ave Battle Creek MI 49015 USA Tel: 1-249-968-3351 Fax: 1-249-968-6913 (8am to 5pm Eastern Standard Time) www. rocktron. com Rev. [. . . ]