User manual ROCKTRON RB60

[. . . ] Keep these instructions Heed all warnings Follow all instructions. Clean with dry cloth Copyright © 2003 GHS Corporation All Rights Reserved. Precautions Continued. . . . Do not block any ventilation openings (if applicable). Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. [. . . ] This pedal runs on a 9 Volt Battery, if a 9Volt DC adapter is the used please follow adapter manufacturer's operation instructions. Only used attachments/accessories specified by the manufacturer. Do not use this product with any case, stand tripod, bracket or table that is not specified by the manufacturer. Insure that the case, stand, tripod, bracket etc. is properly adjusted and setup (follow all instructions). Extra care and caution should be taken to avoid tip over and injury. Unplug this apparatus during lightening storms or when unused during long periods of time. Refer all service to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power supply or plug is damaged, liquid has been spilled or objects have fallen into the apparatus or if the apparatus has been exposed to rain or moisture, does not operate normally or has been dropped. DO NOT ATTEMPT TO SERVICE THIS EQUIPMENT. Turning the control counter-clockwise decreases the number of repetitions. Active LED - When lit the pedal is "active" or "on" Time Control - Adjusts the length of delay. Turning the control clockwise increases the length of the delay. Turning the control counter-clockwise decreases the length of the delay. This control is used in conjuction with the "Short/Shorter" switch ( see point 5). Short/Shorter Switch - When the switch is out or in the "Short Position - the delay time in milliseconds is set between 200ms and 400ms. When the switch is "in" or in the "Shorter" position the delay time in milliseconds is set between 0ms and 200ms. The actual delay time is then adjusted using the "Time" control (see point 4) 2 3 4 5 Bottom Left Side Right Side 6 Output Jack - Using a standard guitar cable with a 1/4" jack, plug into the input of your guitar amplifier or next stomp box Input - Using a standard guitar cable with a 1/4" jack, plug the output of your distortion pedal or your guitar into this jack. If using in an effects loop plug the cable from the "send jack" on the amp or effects unit to this jack. On/Off Switch - This switch determines whether the pedal is "active" or "bypassed" - When "active" the blue LED will be lit. [. . . ] DC 9V Input - To use external power (not provided) use only a 9-Volt DC adapter 9-Volt Battery Compartment - to access pull on small tab labeled "OPEN". Always remember to unplug your guitar cords from the pedal to conserve battery life. Some battery drain may take place when unit is plugged in (even if the unit is bypassed). 7 8 9 10 Specifications Maximum Input Input Impedance Current Consumption Power Requirements +10dBu 1M ohm 27ma 9VDC <=300ma * CE Approved * Hints and Tips: Digital Delay pedals usually sound better when placed after distortion. Thus, if you are using a distortion pedal, place the Short Timer after the distortion pedal in the signal chain. [. . . ]