User manual ROCKTRON RT80

[. . . ] This will help insure compliance with the Directive(s). Precautions NOTE: IT IS VERY IMPORTANT THAT YOU READ THIS SECTION TO PROVIDE YEARS OF TROUBLE FREE USE. · All warnings on this equipment and in the operating instructions should be adhered to and all operating instructions should be followed. · Do not use this equipment near water. [. . . ] CHROMATIC TUNER section This built-in Chromatic tuner allows you to tune your guitar without unplugging from your amplifier. Please see "Built-in Chromatic Tuner Functions" for a more detailed description on how to operate the tuner. POWER switch & LED Turns the amp ON and OFF. When the LED is lit, the amp is on. 10 11 1 REV/CH FTSW (Footswitch) Jack To control CHANNEL selection, plug a single footswitch* into this jack. To control REVERB ON/ OFF and CHANNEL selection, us a double footswitch* with a stereo 1/4" jack. EFFECTS RETURN / SEND Jack 1/4" jacks allow you to connect to an effects processor. Plug a shielded guitar cable into the SEND jack of the RT80 into the INPUT of the "loop" section on the effects processor. Use another shielded guitar cable from the OUTPUT of the "loop" section of the effects processor to the RETURN jack on the RT80. OUTPUTS -PREAMP 1/4" jacks allow you to connect two seperate powered speaker cabinets or directly into a stereo power amp - like the Rocktron Velocity 100 and from the power amp into two 4x12s, a stereo 4x12 or a stereo 2x12 cabinet. The preamp output is controlled by the master volume control. OUTPUT - LINE OUT The 1/4" jack allow you to connect to a speaker simulator and into a PA system or recording device. You may also run the signal out to a power amp with volume controls and from there into a speaker cabinet. The line output is not controlled by the master volume control. * Rocktron Rampage single (RFS1) and double (RFS2) footswitches are available and sold separately. 2 3 4 Built-in Chromatic Tuner Functions 4 2 1 1 3 On/Off button Press this button to engage the tuner function. [. . . ] TUNE b # Flat In Tune Green LED Sharp If the LED(s) to the right of the center green LED are lit, then the note is sharp. Tune the string down until the center green LED is lit - the note should then be "in tune". RT80 Specifications Power Output Speakers EQ Treble Middle Bass Line Preamp 80 Watts 12" Velocity High Definition by Rocktron Active Shelving Active Bandpass Active Shelving 1/4" jack 2x1/4" jack 1x4" jack 2x1/4" jack Overdrive and Clean (Footswitchable) Spring (Footswitchable) Bandstop 20"H x 12" W x 18"D 38. 38 lbs. (17. 40kg. ) 100 Volts AC 50/60Hz or 117 Volts AC, 50/60Hz or 220/240 Volts AC, 50/60Hz, as specified on chassis Outputs: Headphone Output Effects Loop Channels Reverb Scoop Dimensions Weight Power Requirements Check out some of our other products: Rack Gear: Gainiac (preamp w/12ax7 tube) Chameleon 2000 (preamp w/multi-effects) Voodu Valve (preamp w/12ax7 tube and multi-effects) Prophesy (our top of the line preamp with multi-effects) Intellifex On Line (Multi-effects processor) HUSH Super C (guitar noise silencing system) Stomp Boxes: Rampage Distortion, Tsunami Chorus, Austin Gold Overdrive, Orange Peel Phaser HUSH The Pedal, Surf Tremolo Guitar Amplifiers: RepliTone (Digital Guitar Amplifier with Built-in Multi-effects) RT122C (120 W 2x12 Amp w/Stereo Chorus, Reverb & Built-in Chromatic Tuner) ACOUSTIC (60 Watt Acoustic Amp with Chorus & Reverb) R50C (50 Watt 2x8"Guitar Amp w/Reverb & Chorus) R20 (20 Watt 1x8"Amp w/Reverb) R10 (10 Watt 1x6"Guitar Amp) Foot Controllers: MIDI Mate (Midi Foot Controller) All Access (Midi Foot Controller) AGX (Automatic Gain Expander) Rocktron's patented AGX system solves the long standing problem encountered by guitar players when using high gain distortion. [. . . ]