User manual ROCKTRON STUDIOHUSH

[. . . ] · The power cord should be unplugged from the outlet when left unused for a long period of time. DO NOT ATTEMPT TO SERVICE THIS EQUIPMENT. THIS EQUIPMENT SHOULD BE SERVICED BY QUALIFIED PERSONNEL ONLY. DO NOT MAKE ANY INTERNAL ADJUSTMENTS OR ADDITIONS TO THIS EQUIPMENT AT ANY TIME. [. . . ] FAILURE TO FOLLOW THESE INSTRUCTIONS MAY VOID THE WARRANTY OF THIS EQUIPMENT, AS WELL AS CAUSING SHOCK HAZARD. OPERATING TEMPERATURE Do not expose this unit to excessive heat. This unit is designed to operate between 32° F and 104° F (0° C and 40° C). This unit may not function properly under extreme temperatures. Copyright © 2000 GHS Corporation All Rights Reserved. 1 1 2 3 4 5 6 7 8 9 10 11 INPUT JACKS - LOW AND HIGH Connect the output of your guitar to one of the 1/4"input jacks with a shielded guitar cable. Select LOW for normal, or HIGH for extra gain. Plugging into the LOW input will attenuate your guitar's signal cooling down a "hot" guitar. These two jacks provide slightly different input levels. Experiment with these and adjust to your tastes. 2 PREAMP GAIN - DRIVE Turning this knob clockwise determines the amount of gain (or distortion) added to the signal. 3 PREAMP GAIN - CLEAN This knob controls the Clean Channel Level. 4 CH SELECT - Button & DRIVE LED Channel Select button - allows you to select between the DRIVE channel or the CLEAN channel. The DRIVE LED is ON (or lit) when the DRIVE channel is active. 5 MID SCOOP button Provides a fixed "scoop" of te mid frequencies for a "metal" sound. 6 MASTER - Volume Control The MASTER volume control adjusts the overall sound level. 7 REVERB control Adjusts the amount of reverb added to your guitar's signal. Turn the knob clockwise to increase the effect. 8 TREBLE/MID/BASS controls Tone controls or EQ. (Note: you might have to first tune one string on the guitar by ear to match the actual note if the piano is out of standard tuning or if tape player you are playing along with runs slower or faster than normal). Once you have one note on the guitar tuned to the source - simply play that note on the guitar - while the note is "ringing" press the Auto Calibration button. The tuning pitch of the tuner will automatically be shifted the match the pitch of the audio source. Release the button and tune the remaining strings as normal with the tuner. The tuner at this point has automatically adjusted the tuning range to match that pitch. To reset the tuner to standard 440Hz pitch you turn the tuner off and then back on again. NOTE LED display: These LEDs show the note being tuned. The LED under the note being tuned will be lit. TUNE LED display This series of 5 LEDs shows you if the note being played (tuned) is either sharp or flat. 2 3 4 To Tune: 1) Turn on tuner function 2) Play a note on your guitar. The tuner automatically senses the note being played and will show you the note which is the closest to the one being played by lighting the appropriate LED in the NOTE LED display. [. . . ] The tuner automatically senses the note being played and will show you the note which is the closest to the one being played by lighting the appropriate LED in the NOTE LED display. C D E F G A B # 3) The "TUNE LED display shows by "how much" the guitar is out of tune from the note being played (in standard 440Hz tuning) indicated in the NOTE LED display. If the LED is to the left of the Center green LED the note is flat. Tune the string up until the LED reaches the Center green LED. [. . . ]