User manual ROLAND CB-61JN

[. . . ] install in accordance with the manufacturers instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. [. . . ] Since you can play chords even when using this effect, you can use it to fatten the sound of your chordal playing as well. You can switch to DELAY or the LOOPER function by positioning this knob. When the knob is at DELAY, this functions as a delay. When the knob is positioned at LOOPER, this functions as a looper. * The scale indications for DELAY and LOOPER are just a general guide. Be sure to check the actual sound as you adjust the effect. The indicator lights up when DELAY or LOOPER is on and goes out when it's off. You can also switch DELAY on and off using an optional footswitch pedal. This will blink in synchronization with the delay time. When you press the switch twice, the delay time will be set to the time interval at which you pressed the switch. The ON indicator lights up when EFX is turned on, and goes out when EFX is turned off. Description This reverb simulates the short reverberant sound heard within a room. Turning the knob clockwise makes the effect progressively more intense. Turning the knob clockwise makes the effect progressively more intense. The switch lights in red when the POWER SQUEEZER function is on and goes out when the POWER SQUEEZER is off. Switching on the POWER SQUEEZER function allows you to reduce the amp's output to volume levels that are suitable for the average home. Switching this on allows you to produce a sound that preserves the same tone and balance at volume levels that are suitable for the average home. * The POWER SQUEEZER function affects only sounds input through the BASS INPUT jack. it has no effect on sounds input via the AUX IN jack. * The POWER SQUEEZER function will also affect the output from the LINE OUT and RECORDING OUT/PHONES jacks; this is normal and does not indicate a malfunction. Before making any connections, make sure that this pin assignment is compatible with that of all your other devices. * To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices before making any connections. [. . . ] This is a sweet sound suitable for finger picking. By applying compression deeply, and adding a little bit of reverb, you can obtain a sound that sustains well. Also, if you apply chorus when you play melodies, you'll get a sound that has lots of presence. If you're creating a jazz sound and want it to be warm and smooth, turn ON [SHAPE] switch, and lower [TREBLE] knob so that the picking sound does not become obtrusive. [. . . ]