User manual ROLAND CE-2B

[. . . ] They provide information concerning the proper operation of the EXR-5s/EXR-3s. Be sure to keep this manual in a safe place for future reference. No part of this publication may be reproduced in any form without the written permission of Roland Europe S. The EXR-5s/EXR-3s's sounds are based on full-length (uncompressed) waveforms, which is unique in this price range. [. . . ] To transpose the keyboard down, hold down [­] while pressing [0]~[9] (in that case, you can transpose the pitch down by up to 9 semitones). Here's an example: to hear an "E" each time you play a "C", select "4". All other notes will be shifted by the same amount, so that you end up sounding in E major when you actually play in C major, etc. the corresponding value and the TRANSPOSE icon appear in the display. (3) To switch the Transpose function back off, repeat steps (1) and (2), this time entering the value "0" (no transposition). Note: This setting can be saved to a User Program (see p. Note: There is also a function that allows you to specify which section(s) the Transpose function should apply to. (4) Press another "big" button in the DATA ENTRY section to leave this function. Its value is added to the current transposition interval until you reset it to "0" or until you switch off your EXR-5s/EXR-3s. (2) Press the SELECT [®] button once to select the following parameter: You can also directly enter the desired interval by pressing the corresponding numeric key. To transpose the keyboard down, hold down [­] while pressing [0]~[6] (in that case, you can transpose the pitch down by up to 6 semitones) As soon a you select a value other than "0", the TRANSPOSE icon starts flashing to signal that the EXR-5s/EXR-3s is applying global transposition to all sections. Note: Keyboard Touch applies to all parts you can play yourself (the "Keyboard parts"): Main, Split, and Dual. The BENDER/MODULATION lever to the left of the keyboard can be used to add two kinds of effects to the Keyboard-part notes. You can even use these effects simultaneously if you like. (1) Press the lever towards the rear of the EXR-5s/EXR-3s to add a vibrato effect ("wobble") to the notes you are playing. The Modulation axis can also be used for switching between the slow and fast Rotary speeds (if the "Rotary" effect is assigned to the MFX). (2) Turn the lever to the left to temporarily lower the pitch of the notes you are playing. Turn it to the right to raise the pitch of your notes. EXR-5s/EXR-3s (3) In either case, you can release the lever if you no longer need the effect. Note: If necessary, you can change the Pitch Bend interval. Note: Modulation is not avalaible when the MFX type= "Rotary". In that case, the modulation axis of the lever is used for switching between the fast and slow speeds. [. . . ] (2) Hold down the [USB], [ONE¥TOUCH] and [ACOUSTIC] buttons while switching the EXR-5s/EXR-3s back on again. the display briefly shows "DISABLED". This setting is remembered, so that next time you want to listen to a demo song, you have to repeat the above procedure. Use the following procedure to ensure that the Arranger cannot be started or stopped: (1) Switch off the EXR-5s/EXR-3s. [. . . ]