User manual ROLAND DH-01

[. . . ] The specific thing that must not be done is indicated by the design contained within the circle. In the case of the symbol at left, it means that the unit must never be disassembled. The symbol alerts the user to things that must be carried out. The specific thing that must be done is indicated by the design contained within the circle. [. . . ] 013 · For everyday cleaning wipe the unit with a soft, dry cloth or one that has been slightly dampened with water. To remove stubborn dirt, use a cloth impregnated with a mild, non-abrasive detergent. Afterwards, be sure to wipe the unit thoroughly with a soft, dry cloth. 402 FP-7 Attach at left side. Read "attachment method B. " · Never use benzine, thinners, alcohol or solvents of any kind, to avoid the possibility of discoloration and/or deformation. 556 · · · · * * Holder (with two pieces of Velcro strap) Two cushions One cable clip Four screws A CD drive is not included. Refer to the Roland website for details on Compatible CD Drives. As of February 2007 * * * * You can't use the DH-01 with a model that's not supported. If your model is not in the above list, refer to owner's manual of your model. Refer to the Roland website for details on supported models. In the interest of product improvement, the specifications and/or appearance of this unit are subject to change without prior notice. · When connecting / disconnecting all cables, grasp the connector itself--never pull on the cable. This way you will avoid causing shorts, or damage to the cable's internal elements. 921 · Try to prevent cords and cables from becoming entangled. Also, all cords and cables should be placed so they are out of the reach of children. 104 · To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices before making any connections. * 0 4 5 6 6 6 8 9 - 0 3 * Copyright © 2006 ROLAND CORPORATION All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION. Attach the CD drive to the holder (applies to all models) Attach the CD drive to the holder as shown in the illustration below that depicts the completed assembly. 2. Attach the assembled drive and holder to your piano Attachment method A 5. Using the four included screws, fasten the holder (with the attached CD drive) to the bottom of your digital piano as shown in the illustration. Attachment method B 5. Remove one of the rubber feet from the front left of the digital piano's bottom surface (see the illustration for step 7). * Use a Phillips driver to remove the rubber foot. Move the headphone hook as necessary (see the illustration for step 7). Using two of the included screws, fasten the holder (with the attached CD drive) to the bottom of your digital piano as shown in the illustration. Completed assembly Schematic diagram Top Buckles Fasten it securely so that it does not wobble. Holder Cushions CD drive Bottom Fasten it securely so that it does not wobble. Velcro strap Attachment procedure 1. Change the position of the Velcro strap appropriately for the size of your CD drive, as shown in the illustration below. 3. [. . . ] Peel off the backing when you're ready to affix the cushions. Use these cushions if you find it difficult to fasten your CD drive using the Velcro strap. Carry out this procedure with the Velcro straps attached. Use the included cable clip to bundle the cable as necessary. [. . . ]