User manual ROLAND DR-30 MANUAL 2

[. . . ] Owner's Manual We'd like to take a moment to thank you for purchasing the Roland DYNAMIC MICROPHONE. Before using this unit, carefully read the section entitled: "IMPORTANT NOTES. " This section provides important information concerning the proper operation of the unit. Additionally, in order to feel assured that you have gained a good grasp of every feature provided by your new unit, this manual should be read in its entirety. [. . . ] · When using the microphone with the stand recommended by Roland (ST210 or ST-259), make sure the legs of the tripod are opened wide enough to keep the equipment from falling over. The stand must be carefully placed so it is level and sure to remain stable. · For everyday cleaning wipe the unit with a soft, dry cloth or one that has been slightly dampened with water. To remove stubborn dirt, use a cloth impregnated with a mild, non-abrasive detergent. Afterwards, be sure to wipe the unit thoroughly with a soft, dry cloth. · Never use benzine, thinners, alcohol or solvents of any kind, to avoid the possibility of discoloration and/or deformation. 1/4" PHONE PLUG TALK SWITCH ON XLR TYPE CONNECTOR DOUBLE CONDUCTOR SHIELD MICROPHONE HOLDER SCREW ADAPTER (5/8"­27, 3/8"­16) WARNING · Keep the included Screw Adapter in a safe place out of children's reach, so there is no chance of them being swallowed accidentally. 1kHz FEATURES · Cardioid handheld mic with shock-absorption for reduced handling noise · Silent-Switch Design for reducing power on/off switching noise · Talk Switch comes with a lock to prevent unintended operation POLAR PATTERNS OPERATION 1. Connect the XLR connector to the microphone. Connect the other side (standard phone jack) of the cable to the input jack of the unit you use, such as mixer. If you wish to install the microphone to a microphone stand, use the supplied microphone holder. If the microphone holder does not fit the stand, try exchanging the screw adapter. (U 5/8, W 3/8) FREQUENCY RESPONSE TALK SWITCH DR-30 has a Talk Switch with a locking system. This specially designed switch may be locked in the "ON" position to prevent accidental turn-off during use. · To lock, slide the switch up into the "ON" position. [. . . ] 4). Locked Position Unlocked Position Do not turn Do not turn the screw the screw in the clockwise to lock "OFF" position MAIN SPECIFICATIONS 180. 5mm 7­1/8" 50mm 2" 22mm 7/8" ON OFF ON fig. 4 PIN ASSIGNMENT The pin assignment for XLR type connectors is as shown below. Before making any connections, make sure that this pin assignment is compatible with that of all your other devices. MICROPHONE GND HOT 1 2 3 HOT 2 MICROPHONE CABLE GND 1 3 Type. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Dynamic (with Talk Switch) Frequency Response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100--13, 000 Hz Output Impedance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 600 Polar Patterns . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Cardioid Sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -52 dB (0 dB=1 V/Pa, 1 kHz) Dimensions (dia head × length × dia grip) . . . . . . . . . . . . . . . . . . . . . . . . . . 50 × 180. 5 × 22 mm Weight. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 305 g Accessories Microphone cable (4. 5 m) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Microphone holder . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Screw adapter (5/8"­27, 3/8"­16) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Carrying case . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 * In the interest of product improvement, the specifications and/or appearance of this unit are subject to change without prior notice. COLD COLD(GND) GND HOT [. . . ]