User manual ROLAND EP-85 MIDI IMPLEMENTATION

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] " The boundary key is called the "split point. You can change the location where the keyboard is divided (the split point) within the range of B1 through B6. The key that you want to specify as the split point. NOTE When you continue holding the [SPLIT] button, the currently specified split point will be displayed. The key you pressed becomes the split point, and belongs to the left-hand section of the keyboard. You can also change the setting by pressing the [-] or [+] button while continuing to hold down the [SPLIT] button. If you hold down the [SPLIT] button and simultaneously press the [-] and [+] buttons, the setting will return to its original value (F#3). NOTE In Split play, the damper pedal will be applied only to the right-hand area of the keyboard. If you want the damper pedal to be applied to the left-hand area, refer to "Applying the Damper Pedal to the Left Keyboard Area" (p. The tone played on the right side is the tone in use before the [SPLIT] button is pressed, while the bass tone is played on the left side. The split point key is included in the left-hand keyboard area. When you're playing along with a song, you can make sure that your playing is in time with the song by sounding a count before the song starts playing. Sounding a "count sound" leading up to playback of a song is called "Count-In. " On the ep 880, if you playback a song while the metronome is sounding, two measures of lead-in count will be heard at the beginning of the song. NOTE During the count-in, the count measure is indicated in the display as "­2" then "­1. Select the song that you want to play back (p. Each time you press the [SONG/TEMPO] button, the tempo and the currently selected song number (prefixed by "S. While the tempo is displayed, the [SONG/TEMPO] button indicator will light in green. While the song number is displayed, it will light in red. You can also change the tempo during playback. Holding down the button makes the tempo change (slow down) continuously. If you press the [-] and [+] buttons simultaneously, you will return to the basic tempo of the song (the tempo before you modified it). [. . . ] a problem such as a loose MIDI cable occurred. Make sure the MIDI cables are correctly hooked up. Press any button, and you can cancel the error message. Master Tuning Selecting a temperament Specifying the keynote Stretch tuning Applying the damper pedal to the left-hand keyboard area MIDI send channel settings Local Control Song Backup Saving the Master Tune setting Transmitting a recorded performance V-LINK Depth of the Reverb effect Depth of the Chorus effect Dual Balance Damper pedal's resonance level Beat of metronome Metronome volume p. [. . . ]