User manual ROLAND FR-3S

[. . . ] Unauthorized use of the demo songs for purposes other than private enjoyment is a violation of applicable laws. 1~16) 00H~7FH (0~127) 01H~7FH (1~127) Data byte Status Model ID #2 (FR-3 V-Accordion) Command ID (DT1) Address MSB: upper byte of the starting address of the data to be sent bbH Address: upper middle byte of the starting address of the data to be sent ccH Address: lower middle byte of the starting address of the data to be sent ddH Address LSB: lower byte of the starting address of the data to be sent eeH Data: the actual data to be sent. [. . . ] Bank Select (Controller number 0, 32) Status 2nd byte BnH 00H BnH 20H n = MIDI channel number: mm = Bank number MSB: ll = Bank number LSB: Expression (Controller number 11) Status 2nd byte BnH 0BH n = MIDI channel number: vv = Expression: 3rd byte mmH llH When Active Sensing is received, the FR-3 starts monitoring the intervals of all further messages. While monitoring, if the interval between messages exceeds 420 ms, the same processing will be carried out as when All Sounds Off, All Notes Off and Reset All Controllers are received, and message interval monitoring will be halted. start Status FAH · When an FA message is received from an external MIDI device such as sequencer, the FR-3 sends all necessary MIDI information for a song header setup: Treble, Orchestra, Bass/Free, Orchestra Bass, sound setup. Expression messages are used for musical expression within a performance, e. System Exclusive Message status An ID number (manufacturer ID) to indicate the manufacturer whose Exclusive message this is. This message is transmitted when the [METRONOME] switch is pressed after assigning the "2" option to the "MFn" parameter. The System Exclusive Messages received by the FR-3 are messages related to Data Set (DT). This message is transmitted when the [METRONOME] switch is pressed after assigning the "2" option to the "MFn" parameter. System Exclusive Message status An ID number (manufacturer ID) to indicate the manufacturer whose Exclusive message this is. EeH, F7H ffH, sum Byte Explanation F0H Exclusive status 41H ID number (Roland) 10H Device ID 00H Model ID #1 (FR-3 V-Accordion) 7CH Model ID #2 (FR-3 V-Accordion) 12H Command ID (DT1) aaH Address MSB: upper byte of the starting address of the data to be sent bbH Address: upper middle byte of the starting address of the data to be sent ccH Address: lower middle byte of the starting address of the data to be sent ddH Address LSB: lower byte of the starting address of the data to be sent eeH Data: the actual data to be sent. [. . . ] Bulk Dump allows you to transmit a large amount of data at once, and is convenient for storing settings for the entire unit on a computer or sequencer. *1 O X is selectable *2 Recognized as M=1 even if M1 *3 SysEx used for Bulk Dump only *4 Transmit Start (FA) and Stop (FC) Mode 2: OMNI ON, MONO Mode 4: OMNI OFF, MONO O: Yes X: No When you need repair service, call your nearest Roland Service Center or authorized Roland distributor in your country as shown below. [. . . ]