User manual ROLAND JUPITER-6 SERVICE MANUAL

[. . . ] The manual should be saved and kept on hand as a convenient reference. Main Features Quick and Easy Sampling! Sample via Line/Mic input or use the onboard mic. Also operates on batteries. Pro Quality Effects Onboard! 29 DSP effects including Filter, Lo-Fi, Isolator and unique effects such as Subsonic and new looper FX. Realtime Performance! 3 rubber control knobs, 12 trigger pads, and an extra Sub Pad for realtime action. Create Your Own Tracks! Record patterns in real time with the Pattern Sequencer, complete with quantize. Perform with smooth triggering from pattern to pattern. More Samples on Memory Card! Store up to 1 GB of samples on optional CompactFlash cards. Also reads WAV/AIFF files from CF cards. Conventions Used in This Manual Operating buttons are enclosed by square brackets [ ]; e. g. , [REC]. [. . . ] Press [LOOP] to make the button light or go dark. [LOOP] lit: Loop playback [LOOP] unlit: One-shot playback Start playback Stop playback If you want a long phrase to continue playing, you'll probably choose Trigger Playback and Loop Playback as the settings here. In the case of a drum sample, you will usually choose Trigger Playback and One-shot Playback so that the sample will play to the end even if you press the pad only briefly. 2. After sampling, the following settings are made automatically. If the length resulting from automatic BPM calculation (p. 33) is less than one measure: Trigger Playback If the length resulting from automatic BPM calculation (p. 33) is one measure or greater: Gate Playback 3. If you assign a long sample to Trigger Playback and One-shot Playback, the sound may continue beyond what you would like. To stop the sound, change the setting to Loop Playback and then press that pad. Alternatively, you can press [CANCEL] four times in rapid succession to get it to stop sounding. 29 Chapter 4. Changing the Settings of a Sample 1. Make sure that [PATTERN SELECT] is not lighted. If it's lit, press [PATTERN SELECT] to switch it off. Press the pad that plays the sample whose Gate/Trigger setting you want to change. The pad lights and the sample begins playing. This pad is now the current pad. Changing Only the End Point 1. Make sure that [PATTERN SELECT] is not lighted. If it's lit, press [PATTERN SELECT] to switch it off. Hold down [MARK] and press the pad that plays the sample whose setting you want to change. The pad lights and the sample begins playing. This pad is now the current pad. 2. 2. If Gate Playback (p. 29) is selected, continue holding down the pad. When you reach the point that you want to specify as the Start Point, press [MARK]. [MARK] starts blinking, and "---" appears in the display When you reach the point that you want to specify as the End Point, press [MARK] once again. When the setting has been made, [MARK] lights. If Gate Playback (p. [. . . ] Service Division 22-32 Pun Shan Street, Tsuen Wan, New Territories, HONG KONG TEL: 2415 0911 Parsons Music Ltd. 8th Floor, Railway Plaza, 39 Chatham Road South, T. S. T, Kowloon, HONG KONG TEL: 2333 1863 U. A. E. Zak Electronics & Musical Instruments Co. TEL: (04) 3360715 MEXICO UNITED KINGDOM Roland (U. K. ) Ltd. Atlantic Close, Swansea Enterprise Park, SWANSEA SA7 9FJ, UNITED KINGDOM TEL: (01792) 702701 CENTRAL/LATIN AMERICA ARGENTINA Instrumentos Musicales S. A. [. . . ]