User manual ROLAND MDS-20

[. . . ] Additionally, in order to feel assured that you have gained a good grasp of every feature provided by your new unit, Owner's manual should be read in its entirety. The manual should be saved and kept on hand as a convenient reference. [. . . ] Roland and V-Drums are either registered trademarks or trademarks of Roland Corporation in the United States and/or other countries. A very solid and stable stand featuring ball clamps that allow precise adjustments for all pads and cymbals. ⷠCables are inside the pipes, providing a clean look and quick breakdown or setup. Use the cable clips as shown below, to secure the cables. * We recommend using an optional Roland drum mat (TDM series) to prevent scarring or discoloration of flooring by the rubber feet of the stand. Sound module mounting pipe (including the mounting plate) Curved pipe L 600mm, Center pipe 550 mm (connection cables are inside) Curved pipe R Snare pipe 300 mm Straight pipe 625 mm Straight pipe 650 mm L Straight pipe 650 mm R Straight pipe 520 mm Cymbal arm x 3 Pad arm x 2 Holder x 2 Pad mount x 2, Memory lock (for pad mount) x 2 8 kg / 37 lbs 1 oz (including Pad Mounts and Cymbal Mounts) * In the interest of product improvement, the specifications and/ or appearance of this unit are subject to change without prior notice. Be sure the two pipes at the ends tare no more than 1. Doing so can damage the cables inside the stand or cause the stand to fall over. * Never pull on any cables with excessive force. The drum key, then remove the ball clamp. * There are labels on the ends of the cables allowing easy connection to your sound module. For about connections, refer to the owners manual that came with your sound module. [. . . ] The names on the labels correspond to trigger input jack names as follows. (input names shown here are for the TD-12 modules) Working in order, following numbers 1 ­ 8 in the illustration, attach the curved pipes to the straight pipes. [. . . ]