User manual ROLAND RC-3

[. . . ] Once you delete these, they cannot be recovered. Please back them up as described in "Backing up to your computer" (p. * This device will enter Sleep mode (power conservation mode) when ten hours have elapsed since the last operation, or since the last audio input while in Stop mode. If you want to prevent the device from entering Sleep mode, hold down the pedal while you turn on the power, and continue holding down it down for five seconds (p. [. . . ] While the phrase is being deleted, the number in the display and the PLAY indicator will blink rapidly. * Never turn off the power while the PLAY indicator is blinking rapidly. This may cause all saved data to be lost. One-shot playback will play the phrase once from the beginning to the end, and then stop automatically. You can undo/redo/clear by holding down the pedal for at least two seconds. Operation Display Explanation Hold down the pedal for at least two seconds during playback or overdubbing; Undo Un the recording or the most recent overdubbing will be cancelled. If you want to restore the cancelled sound, hold down the pedal for at least two seconds Redo rE once again. * You can't Redo after Undoing a recorded phrase. Hold down the pedal for at least two seconds while stopped; the current phrase will be cleared. (Clear is temporary; phrases saved in phrase memory will not be deleted. Press the [WRITE] button once again; the phrase will be saved as a one-shot phrase. If you decide not to save the phrase, press the [TAP TEMPO] button, the [RHYTHM ON/OFF] button, or the pedal. * Overdubbing is disabled when one-shot playback is in effect. If the pedal is pressed during playback of the phrase, the phrase starts playing from the beginning again (retrigger playback). If you want to overdub, you must re-save the phrase as a Loop phrase. * If you want to stop a One-Shot phrase while it is playing back, press the pedal twice within a period of 0. "Auto recording" starts recording the moment you begin playing your guitar or play back your audio player. "Count-in" sounds the rhythm for one measure before recording starts. When you press the pedal, the REC indicator will blink rapidly, and the rhythm will sound for one measure. (You can stop by pressing the pedal during this time. Hold down the [TAP TEMPO] button for at least two seconds. Use the [ ] / [ ] buttons to select the desired recording mode, and then press the pedal to start recording. [. . . ] Remove the old battery from the battery housing, and remove the battery snap connected to it. Connect the battery snap to the new battery, and place the battery inside the battery housing. * Be sure to carefully observe the battery's polarity (+ versus -). Slip the coil spring onto the spring base on the back of the pedal, then close the pedal. [. . . ]