User manual ROLAND SH-2

[. . . ] The manual should be saved and kept on hand as a convenient reference. The SH-2's Low Boost function, which compensates for smaller speakers and other systems with insufficient low end, is set to ON at the factory. When using the SH-2 with large speakers or a PA, we recommend turning this feature off. While holding down [2/B], turn on the SH-2's power. Press [VALUE ] to switch the function to " 3. [. . . ] Press one of the buttons from [1/A] through [8/R] to select a bank (1­8). Once again, press one of the buttons from [1/A] through [8/ R] to select a Performance number. Play the MIDI keyboard connected to the MIDI IN connector or use the Preview (note-entry) function to play sounds. When using an external MIDI keyboard to play sounds, either set it to the MIDI channel for the Part you want to play (p. 84), or turn the Remote Keyboard Switch (REMOTE) on (p. When using the Preview function to play sounds, the sounds from Patches in Parts selected with the Part buttons are played. blinking Playing Sound in More Than One Part (Multitimbre) When composing songs or performing data, the Patch used in each Part may be assigned to the Performance Parts, which are then set to separate MIDI channels. This type of sound generator, in which each Part is performed independently from the others, is called a mutitimbral sound generator. The following section explains the use of the SH-2 as a mutitimbral sound generator. Confirm that the SH-2 is in Performance mode. Assign a Patch to each Part (see previous sections). Next, set the MIDI channel for each Part. Use this feature to achieve fat, complex sounds simply and easily. Editing a Performance You can change these settings for the Patch or Rhythm Set assigned to each Part even in Performance mode. You can save changes to the settings to each Patch or Rhythm Set. However, the parameters described in the following section, "Settings Affecting the Overall Performance, " are set for the Performance itself and can be saved to each Performance. With the SH-2's Part Stack function, merely stacking (simultaneously pressing multiple Part buttons) allows you to have all these Parts act as if they were all set to the same MIDI channel. Regardless of the individual channel settings in each of the Parts used in a stack, messages are received only via the MIDI channel for the Part with the lowest Part number. Confirm that the SH-2 is in Performance mode. Assign the Patches you want to have played to their respective Parts (p. Simultaneously press the buttons ([1]­[4/R]) for any Parts you want to have played together. · You can stack up to a maximum of four Parts. · Stacked Parts need not be adjacent; for example, you can stack Part 1 and Part 3. · You cannot set two Part stacks at the same time. · The status of Part Stack can be saved together with the Performance settings, using the write procedure. [. . . ] Replace only with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions. ADVARSEL! Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering. Udskiftning må kun ske med batteri af samme fabrikat og type. Levér det brugte batteri tilbage til leverandøren. VARNING Explosionsfara vid felaktigt batteribyte. [. . . ]