User manual ROLAND SS-PC1

[. . . ] SUPPORT STAND FOR PC Before using this unit, carefully read the sections entitled: "USING THE UNIT SAFELY" and "IMPORTANT NOTES"(separate document). These sections provide important information concerning the proper operation of the unit. [. . . ] 2) Pla-ce the board as shown in the illustration below, and insert the tripod. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION. The SS-PC1 can support an item within the following ranges of width, depth, height, and weight. * Roland will not be liable for any damage that may occur to an item placed on the stand if the stand falls over, nor for any consequential damage that may occur. Size of notebook computers that can be mounted: Loosen the round nut to adjust the height Up to B4 size Width: 200­390 mm 7-7/8­15-3/8 inches Depth: up to 300 mm up to 11-13/16 inches Height: 21­41 mm 7/8­1-5/8 inches (not including screen) * It may not be possible to mount some designs of notebook computer. As an example, here's how to attach a notebook computer to the stand. * * It may not be possible to mount some designs of notebook computer. The location of the CD-ROM drive or other disc insertion slot will depend on the design of your notebook computer. Insert the disc you're using into your computer before attaching the computer to the SS-PC1. Leave a bit of space * You can tilt the board in a range of ±5 °from the horizontal position. [. . . ] * To avoid damaging your notebook computer, do not fold down its screen while the computer is still held by the stoppers. * To prevent your notebook computer from falling, do not move it or adjust the height while it is still on the stand. [. . . ]