User manual ROLAND V-COMBO

[. . . ] WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION: RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS. IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS WARNING - When using electric products, basic precautions should always be followed, including the following: 1. Do not block any of the ventilation openings. [. . . ] Press an ensemble sound button; the upper part will switch to that ensemble sound. The display will indicate the tone number of that category of sound. 2. Use the [+] button or [­] button to select variations of that category of sound. 46 Storing Your Favorite Settings (Favorites) The organ sound settings and ensemble sound settings for the three parts, along with the Layer and Split status, can be saved as a "favorite" in the VR-700's internal memory. The VR-700's internal memory can store 64 favorites. A set of these 64 favorites can also be backed up to USB memory (sold separately) connected to the USB MEMORY connector. * Some parameters of Function mode are stored independently for each favorite. For details on the parameters stored for each favorite, refer to "Parameter List" (p. 52). fig. pnl-favolite. eps Saving the Current Settings as a Favorite 1. While holding down the [WRITE] button and [BANK] button, press one of the FAVORITE [1]­[8] buttons to specify the save-destination bank. The display will indicate the number of the bank you specified. You don't need to specify the bank over again if you intend to save the Favorite in the current bank. 2. Hold down the [WRITE] button and press one of the FAVORITE [1]­[8] buttons to specify the save-destination favorite number. The display will indicate the favorite number you specified, and the current settings will be saved as a favorite. Initializing the Favorites If you want to erase the 64 favorites stored in internal memory, returning them to their factory settings, execute the Factory Reset operation (p. 26). Selecting a Favorite When the VR-700 is shipped from the factory, the 64 favorites contain various sounds and settings. Try selecting the factory-set favorites, and listen to their sounds. 1. Hold down the [BANK] button and press one of the [1]­ [8] buttons to select a bank. While you hold down the [BANK] button, the button corresponding to the currently selected bank will light. 2. Press one of the [1]­[8] buttons to select a favorite. The selected button will light. 3. Play the keyboard and try out the sound. If you're selecting a different favorite within the same bank, there's no need to re-specify the bank. 47 Storing Your Favorite Settings (Favorites) Backing up Favorites to USB Memory When you execute this operation, all favorites stored in the VR-700 and the values of system parameters that can be edited in Function mode will be backed up to USB memory. Restoring from USB Memory When you execute this operation, the 64 favorites and the system parameters will be restored into the VR-700's memory from the USB backup. You can choose whether to restore the 64 favorites and system parameters together, or to restore only the 64 favorites and leave the system parameters as they were. When you execute this operation to restore from USB memory, the 64 favorites currently in the VR-700's internal memory and its Function mode system parameters will be erased (overwritten by the restored data). This data cannot be recovered, so we recommend that you back it up before you proceed (p. Connect your USB memory to the rear panel USB MEMORY connector (p. Use the [+] button or [­] button to specify the backup number. You can create up to 99 backups (numbered 01­99) on a single USB memory device. * If you specify a number for which a backup already exists, the decimal point at the right edge of the display will light. * If USB memory is not correctly inserted, the display will indicate . 1. [. . . ] Split . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SPLIT button . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Spring Reverb . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SPRING SHOCK button . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]