User manual ROLAND VEJV1

[. . . ] Additionally, in order to feel assured that you have gained a good grasp of every feature provided by your new unit, Quick Start, Owner's Manual, and Appendices should be read in their entirety. The manual should be saved and kept on hand as a convenient reference. Copyright © 1998 ROLAND CORPORATION All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION. Roland Homepage http://www. roland. co. jp/ Roland US Homepage http://www. rolandus. com/ Introduction Thank you for purchasing the Roland VEJV1 digital studio workstation. [. . . ] This operation cannot be undone by the Undo function. Furthermore, recorded data that was deleted by the Song Optimize operation cannot be recovered. fig. 3-21 3 4 1 5 2 1 2 fig. 3-22_80 Press [PLAY (DISPLAY)]. Hold down [SHIFT] and press [F1 (SONG)]. The Song menu icons will appear. 52 Making a Multi-Track Recording 3 Press [F5 (OPTIM)]. If [F5] does not indicate "OPTIM, " first press [PAGE] so that "OPTIM" is displayed, and then press [F5 (OPTIM)]. "Song Optimize, Execute ?" (execute the Song Optimize operation?) will be displayed. If you decide not to execute the operation, press [F6 (EXIT)]. Press [YES] to execute the Optimize operation. If you decide not to execute, press [NO]. 4 5 fig. 3-23_80 6 When the Optimize operation is completed, you will return to the display where you began. Depending on the situation, it may take some time for the Optimize operation to be completed. Do not turn off the power until Optimize has been completed. For details refer to "Deleting Only Unneeded Performance Data (Song Optimize)" (Owner's Manual p. 169) 53 Making a Multi-Track Recording Recording On a V-Track The VEJV1 has 16 tracks, and each of these tracks has 16 supplementary tracks called V-tracks. The channel fader is used to make fine adjustments to the recording level. In order to record with optimal audio quality, the channel fader should normally be in the position of 0 dB. The assignments of input sources to tracks will be cleared. 58 Making a Multi-Track Recording 5 Select the playback track(s). Hold down [STOP], and press the [STATUS] button of the track(s) that you wish to hear. For this example, hold down [STOP] and press the track 1 [STATUS] button. Hold down [REC] and press the [STATUS] button of the track(s) that you wish to record. For this example, hold down [REC] and press the track 3 [STATUS] button. Select the source that will be recorded on the track. Hold down the [STATUS] button of the track that you wish to record, and press the [SELECT] button of the input channel that you wish to assign. For this example, hold down the track 3 [STATUS] button, and press the input channel 2 [SELECT] button. By continuing to hold down [STATUS] for a time, you can check which source is assigned to which track. 6 7 At this time, the sound of input channel 2 will no longer be output directly from master out. 8 fig. 3-29_80 9 10 Press [FADER] so that the TR (track) indicator is lit. Raise and lower channel fader 3 to hear the volume change. [. . . ] When you change the partition size, the change will take effect after the hard disk is initialized. When the hard disk is initialized, the entire contents of the disk will be erased. Make sure that the hard disk does not contain data you need to keep. If necessary, back up the data to the Roland CD recorder, an external hard disk drive, a DAT tape, etc. fig. 7-05 1 If important data is erased by mistake, there is no way to recover it. [. . . ]