User manual ROLAND VS-1680 USER GUIDE

[. . . ] USER'S GUIDE Before using this unit, carefully read the sections entitled: "IMPORTANT SAFETY INSTRUCTIONS" (p. 2), "USING THE UNIT SAFELY" (p. These sections provide important information concerning the proper operation of the unit. Additionally, in order to feel assured that you have gained a good grasp of every feature provided by your new unit, Quick Start, User's Guide, and Appendices should be read in their entirety. [. . . ] Now that you're in the ballpark, you might use Preview and Scrub to define a precise edit point. Now try the edit: 1. If you don't see "Erase" above [F2], press [PAGE] until "Erase" appears, and then press [F2 (Erase)]. Press the Track 5 STATUS button to select Track 5 for erasure. The STATUS button turns red, indicating it is the track to be edited. You can press more than one STATUS button if you wish to erase more than one track. To deselect a track, press the STATUS button again to change it back to flashing green. Quick Editing Setting Edit Points Using LOCATORS One of the fastest ways to set edit points is to set locators "on the fly, " that is, while your song is playing. Start by clearing the first two locators (if necessary). Press [LOCATOR 1] at the spot where you would like to start an edit. Press [LOCATOR 2] at the end of the section you wish to edit. SPECIAL SHORTCUT: The first four LOCATOR buttons can be used to enter the current time location into the START, END, FROM and TO fields by holding [SHIFT] and the respective LOCATOR button. This moves the timeline to the point where you want to begin erasing. This enters the current time value (recalled by LOCATOR 1) as the "START" point for the edit. This moves the timeline to the point where you want to stop erasing. This enters the current time value (recalled by LOCATOR 2) as the "END" point for the edit. Press [F4 (Exec)] to execute the edit based on the parameters you've defined. If it didn't work, press [UNDO] and then [ENTER] to "undo" the edit. LOCATOR Editing Example: Track Erase Below is a specific example of how to perform one of the most basic edits on the VS-1680, Track Erase. In Track Erase, the area of audio between the Start and End points is replaced with silence. Study the basic steps involved in track editing using this example: editing Track 5. Before entering Track Edit mode, set your locators. Locate the point in the song where you want to start erasing. Locate the point in the song where you want to end your erasing. Press [LOCATOR 2]. Precision Editing In the previous example, we used locators to set edit points. This is a fast and easy way to perform most edits. [. . . ] Vaihda paristo ainoastaan laitevalmistajan suosittelemaan tyyppiin. Hävitä käytetty paristo valmistajan ohjeiden mukaisesti. For EU Countries This product complies with the requirements of European Directives EMC 89/336/EEC and LVD 73/23/EEC. For the USA FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ]