User manual ROLLEI NANO 80

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] Select [Execute] with the / buttons, and press the button. View the changes on the corrected image. To save your corrected image, select [Confirm] with the / buttons, and press the button. When this process ends, this replaces the original image with the corrected image. EN-22 Attaching Voice Memos A maximum of 30 seconds of audio can be recorded as a memo for captured still images. The voice memo can be recorded only once. Select the image to which you want to attach the voice memo with the / buttons. Select [Voice Memo] with the / buttons, and press the button. Select [On] with the / buttons, and press the button. [VOICE RECORDING] is displayed on the screen and recording starts. To stop recording a voice memo as it is being recorded, press the shutter button again. [VOICE RECORD END] will be displayed and the recording will end. You can set up to 9 prints for each image. Select [Date Print] with the / buttons, and press the button. Select date to [On] or [Off] with the / buttons, and press the button. [On]: The date of the image will also be printed. [Off]: The date of the image will not be printed. Select [Print Enable] with the / buttons, and press the button. Select [Execute] with the / buttons, and press the button. This creates a file containing the DPOF information, and when the operation is finished, the screen returns to the playback mode. The DPOF icon [ ] is displayed on each image that has set up DPOF settings. x 1 E 100- 0001 The date that is printed on the image is the date set on the camera. To print the correct date on the image, set the date on the camera before you capture the image. Refer to section in this manual titled "Setting the Date and Time" for further details. EN-25 Erasing Images Erasing single image / Erasing all images 1. [. . . ] [Exit]:Exit from Images option. EN-39 3. If you select [Single] in the previous step, the figure shown on the right hand side will appear. Select the image that you want to print with the / buttons. Select the [Print Num] (up to 99) with the / buttons. [. . . ]